SOM-1651-002.pdf - 第17页

16 Tg0754-PM-SO 0206-001 7. Rejected Component Discharge Offset When the Recycle Conveyor B is shifted toward the lower right directiion (viewed from the top), plus values must be enterd in the "X [mm] (horizontal)&…

15 Tg0754-PM-SO0206-001

7. Rejected Component Discharge Offset

Fig. 5 "Component Reject" Tab Sheet

(Provided with Recycle Conveyor B)

The tab sheet may look different, depending on which

options are selected.

• Sheet Composition

*1 Recycle Conveyor B X [mm] (Horizontal), Y [mm] (Vertical),

and L [mm] (Height)

Set the offsets to adjust the positional and vertical (height direc-

tion) deviations, compared with the design dimensions (position)

of the Recycle Conveyor located. The values based on the PL-XY

coordinate system must be entered in each text box.

Note



However, if the offset data is deleted for some reason, reset the data.

••

• Sheet Layout

Press the [Unit Offset] tab on the "Offset Data" tab sheet and [Com-

ponent Reject] tab, the following tab sheet appears.

As the machine is adjusted or set when delivered,

do not change carelessly.

CAUTION

16 Tg0754-PM-SO0206-001

7. Rejected Component Discharge Offset

When the Recycle Conveyor B is shifted toward the lower right

directiion (viewed from the top), plus values must be enterd in the

"X [mm] (horizontal)" and "Y [mm] (vertical)" text boxes.

When the level (height) of the box is set lower than the design

value, a plus value must be entered in the "L [mm]" text box.

Fig. 6

Recycle Conveyor B

Component Storage Box B (Small)

Feeder Base 4

Feeder Base 3

PL-XY Coordinate

System

X(+)

Y(+)

17 Tg0754-PM-SO0206-001

8. Troubleshooting

8.1 Scope

8.1.1 Troubleshooting

Refer to "1.1 Troubleshooting" in "Section 2" (the instruction manual

(Vol. 4) of the main machine) for details.

8.1.2 "CHECK" Windows

Refer to "1.2 "CHECK" Windows" in "Section 2" (the instruction

manual (Vol. 4) of the main machine) for details.

8.1.3 "CHECK" List

Table 3

8.1.4 "ERROR" Windows

Refer to "1.4 "ERROR" Windows" in "Section 2" (the instruction

manual (Vol. 4) of the main machine) for details.

Check Codes Display Section (A) Display Section (B)

013401 Recycle Conveyor B Recycle Conveyor B is full (-BPH652)