00196849-02 OG SIPLACE Operation of X and SX-Series without SSC (SW70x).pdf - 第49页
Setting Up X-Feeders - O ver view - Component Table : 49 Setting Up X-Feede rs 1. Centering holes – front 2. Center ing – front 3. Omega profile = Lo wer feeder alignmen t guide 4. Center ing bar – rear
Preparing the Component Set Up - Reading / Interpreting Of The Table Set Up Sheet :
48
Setting Up X-Feeders - Overview - Component Table :
49
Setting Up X-Feeders
1. Centering holes – front
2. Centering – front
3. Omega profile = Lower feeder alignment guide
4. Centering bar – rear
Setting Up X-Feeders - Inserting the Feeder Module :
50
Inserting the Feeder Module
1. Place the front slider guide into the lower alignment
guide.
2. Slide the feeder along the lower alignment guide until
the front centering pin locks.
3. The back centering pin must be in the correct bar.
4. The feeder registers and the status display
illuminates.