ELA Generic Tooling.pdf - 第47页

MACHI NE PROG RAMMI NG STAGE 5 E - FORMFLEX TOOLING User Manual 1.61 44. Sel ect Auto Board (F1). The message ‘Board on rails, remove and continue’ i s displayed. 45. Remove the board from t he rails. 46. Sel ect Continu…

100%1 / 47
MACHINE PROGRAMMING
STAGE 5E - FORMFLEX TOOLING
User Manual 1.59
31. Toggle screen clamp switch to down position (On) (fixed width chase only).
32. Raise the drop down panel and lower the printhead shutter.
33. Press the System button.
34. Select Exit (F8).
35. Select Change Screen (F5).
36. Select Vision Height (F3). The message ‘Table at Vision Height. Check
Tooling Clearance’ is displayed.
37. Select Contact Height (F3).
The following window and menu bar are displayed:
38. Select Continue (F1). The message ‘Table at Contact Height. Check
Tooling Clearance.’ is displayed.
Board
Clamps
Exit
Unload
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Open
Cover
Exit
Unload
Vision
Height
Home
Height
Board
Clamps
Change
Screen
Open
Cover
Exit
Contact
Height
Transpr t
Height
Change
Screen
Open
Cover
Exit
Contact Height Warning
WARNING Check for obstructions between
the Rails and the Screen
Continue
Open
Cover
Exit
Continue
Open
Cover
Exit
MACHINE PROGRAMMING
STAGE 5E - FORMFLEX TOOLING
1.60 User Manual
39. Press the operator switch on the front of the machine covers.
40. Wait until the pneumatic indicator on the front cover displays green.
41. Select Exit (F8).
42. Select Exit (F8).
The following window and menu bar is displayed:
43. Select Continue (F1).
Exit
Vision
Height
Open
Cover
Exit
Leaving Generic Tooling
WARNING You are about to return
to the Setup Page
Clear all tooling setup
equipment before proceeding
Continue Cancel
Continue Cancel
MACHINE PROGRAMMING
STAGE 5E - FORMFLEX TOOLING
User Manual 1.61
44. Select Auto Board (F1). The message ‘Board on rails, remove and
continue’ is displayed.
45. Remove the board from the rails.
46. Select Continue (F1).
47. Select Change Screen (F5).
48. Raise the printhead shutter and lower the drop down panel.
49. Toggle screen clamp switch to the up position (Off) (fixed width chase only).
50. Remove the screen from the printer and release the universal set plate from
the screen.
51. Ensuring correct orientation, refit the screen.
52. Raise the drop down panel and lower the printhead shutter.
53. Press the System button.
54. Go to Stage 6.
Auto
Board
Manual
Board
Continue
Open
Cover
Mode
Load
Data
Edit
Data
Setup
Squeegee
Change
Screen
Change
Tooling
Change
Language
Exit