00198501-02_IM_711.1_R18-1_EN.pdf - 第29页

Station Software V ersion 711.1 (R 18 - 1) / Installat ion Manual 05/2018 Edition 29 The Insert MID and Serial Number dialog box is d i splayed. Figure 5-11: Inserting Machine Ide ntification Number (MID) and se rial num…

Station Software Version 711.1 (R18-1) / Installation Manual 05/2018 Edition

NOTICE

► If you want to change the password for the SIPLACEYats account and an older

station software version is already installed, you will have to uninstall the old station

software version manually first.

► If problems occur during installation of the SIPLACEYats account after that, you will

have to delete the account manually and install it again.

► Click the Next button.

The Select machine type dialog box is displayed.

Figure 5-10: Selecting the machine type

► Select the machine type for which the software shall be configured.

This entry field will be empty in the following cases:

– At initial installation.

– If a previous station software version < 710.x has been automatically uninstalled by the setup

wizard before installation.

– If a previous station software version 710.x (or higher) has been manually uninstalled before

installation. In this case, an initial installation will be performed.

► Click the Next button.

Station Software Version 711.1 (R18-1) / Installation Manual 05/2018 Edition

The Insert MID and SerialNumber dialog box is displayed.

Figure 5-11: Inserting Machine Identification Number (MID) and serial number

► Enter the 8-digit machine identification number in the MID-Number entry field.

► Enter the serial number in the SerialNumber entry field.

NOTICE

You will find the MID and the serial number on an adhesive label on the side of the

protective covers directly below the label for the number of the relevant location. The

number following the dash after the MID specifies the location and is not entered here

(e.g. 00000001-2 stands for location 2).

► Click the Next button.

Station Software Version 711.1 (R18-1) / Installation Manual 05/2018 Edition

The station software is now ready to be installed. The following dialog box is displayed.

Figure 5-12: Checking disk space

Before installing, you can check the available, required and recommended disk space (per drive) to

perform the installation.

NOTICE

For installation and optimal functionality of the machine later on, a free disk space of at

least 5 GB is recommended on the "C:" drive.

► Click the Disk Space button.

The Disk Space Requirements dialog box is displayed.

Figure 5-13: Disk space requirements

► Click the OK button.