Printer 710_810 v8 Transport Rails Module.pdf - 第21页

TRANSPORT RA ILS MODULE REPLACEMENT PROCEDURES Chapter Issue 6 Oct 06 Technical Reference Manual 16.21 REPLACEMENT PROCEDURES Board Clamp Repl acement WARNING BOARD CLAMPS. EXTREME CAR E MUST BE EXERCISED WHEN W ORKING I…

100%1 / 32
TRANSPORT RAILS MODULE
ADJUSTMENTS AND SETTINGS
16.20 Technical Reference Manual Chapter Issue 6 Oct 06
19. If the rail width is incorrect, close the printhead cover/shutter, press the
System button and repeat Steps 16 to 18.
20. If the rail width is correct, close the printhead cover/shutter, press the
System button and select Set.
21. Select Yes to save the information.
22. Using a suitable test board, with the rail width programmed to the board size,
select Cycle Board on Belts.
23. Select Run and ensure the board runs through the entire length of the rail
system for 10 complete cycles, without jamming or excessive clicking of the
board edges.
NOTE
If any jamming occurs investigate the position of the board/snugger clamps
before repeating the check.
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
Chapter Issue 6 Oct 06 Technical Reference Manual 16.21
REPLACEMENT PROCEDURES
Board Clamp Replacement
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
1. Remove the board clamp securing screws and remove the board clamp.
Retain the screws.
2. Place the new board clamp in position on the location plates.
3. Secure the board clamp in position with the screws removed in Step 1.
NOTE
The Board Clamp Setting procedure is not required after board clamp
replacement.
500mm Board Clamp Mechanism
Board Clamp Securing Screws
250mm Board Clamp Mechanism
Board Clamp Securing Screws
TRANSPORT RAILS MODULE
REPLACEMENT PROCEDURES
16.22 Technical Reference Manual Chapter Issue 6 Oct 06
Board Clamp Foil Replacement
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
If the board clamp is fitted to the machine, use the Board Clamp Replacement
procedure to remove and refit the board clamps.
1. Remove the M2.5 x 6mm pan headed slotted screws securing the foil to the
board clamp. Discard the foil and retain the screws.
2. Fit the new foil with the screws removed in Step 1.
Board Clamp Foil Securing Screw (in 4 positions)
Board Clamp Foil Securing Screw (in 8 positions)
View on Underside of
250mm Board Clamp Mechanism
View on Underside of
500mm Board Clamp Mechanism