D39489-BA-PM-EN.pdf - 第24页
24 D39489 | Date 12/2019 Diaphragm pump PJ25481 - 950.50.1 8 Instal lation and c onnection Translation of origina l Installat ion Instructions , english , KNF 125530 - 316634 06/ 18 13 6.2. Electrical con nection DAN G E…
23
D39489 | Date 12/2019
Installation and connection Diaphragm pump PJ25481-950.50.18
12 Translation of original Installation Instructions, english, KNF 125530-316634 06/18
Protect the pump against grease and oils.
Protect the pump from vibrations and jolts.
WARNING
Personal injury and/or damage to property because
of vibration
In conjunction with adjacent components, vibration of
the pump may result in crushing and/or damage to
these components.
Make sure that vibrations of the pump do not re-
sult in hazards associated with adjacent compo-
nents.
Protect the pump against contact and intrusion of foreign mat-
ter.
Foreign matter protection
24
D39489 | Date 12/2019
Diaphragm pump PJ25481-950.50.18 Installation and connection
Translation of original Installation Instructions, english, KNF 125530-316634 06/18 13
6.2. Electrical connection
DANGER
Extreme danger from electrical shock
Only have the pump connected by an authorized
specialist.
Only have the pump connected when the power
supply is disconnected.
When connecting the device to a power source, the relevant
standards, directives, regulations, and technical standards
must be observed.
Connecting pump
1. Compare the supply data with the data on the motor plate. For
maximum operating current of the pump see pump’s type
plate.
The voltage must not vary by more than + 10% and – 10%
from that shown on the type plate.
2. Insert the mains cable plug into a properly installed shockproof
socket.
Ensure sufficient dimensioning of the connection cables.
6.3. Pneumatic connection
CAUTION
Personal injury or damages to property by ejected
protective
plugs
If the
protective plug at the pressure side of the
pump hasn’t been removed, it could be ejected be-
cause of the overpressure during operation.
Remove the protective plug during the installa-
tion.
Only connect components to the pump which are designed for
the pneumatic data of the pump (see Chapter 4, Technical
Data).
If the pump s used as a vacuum pump, safely discharge the
pump exhaust at the pump’s pneumatic outlet.
Connected
components
Pump exhaust
25
D39489 | Date 12/2019
Installation and connection Diaphragm pump PJ25481-950.50.18
14 Translation of original Installation Instructions, english, KNF 125530-316634 06/18
Connecting pump
A marking on the pump head shows the direction of flow.
Confusion between suction and pressure sides can lead to
breakage of connected components on the suction and pres-
sure sides.
1. Remove the protective plugs from the hose connection
threads.
2. Connect the suction line and pressure line (see Chapter 4,
Tab. 7 for mounting dimensions).
3. Lay the suction and pressure line at a downward angle to pre-
vent condensate from running into the pump.