TM2248_Explanation Document of DualLane MachineYS24(DL)YS24X(DL).pdf - 第26页
MDOC - SOFT50073 26 • K AN BAN “Input KA N B AN” scree n at singl e lane m achi ne. <“Clear” button> W h en the “Input KANBAN” screen is opened, “ASSY ” information now in production is displayed. Therefore, when y…
MDOC
-
SOFT50073
25
• KANBAN
<Operation Procedure>
Scan “ASSY” barcode for each lane, and set the “ASSY”, “Surface Info”,
“Board Count”, and “Lane”.
1. Open “Input KANBAN” screen
2. Scan “ASSY” barcode. Then
“Select Lane” screen is displayed.
3. Set “Lane” (Scanning the barcode is
also available).
Input other information as appropriate.
4. Tap the [OK] button.
The information which is set on
“Select Lane” screen is reflected
to “Input KANBAN” screen.
5. Repeat 2-4 procedures
for the other lanes.
5. About Automatic Program Change-Over (Option)
MDOC
-
SOFT50073
26
• KANBAN
“Input KANBAN” screen at
single lane machine.
<“Clear” button>
When the “Input KANBAN” screen is
opened, “ASSY” information now in
production is displayed.
Therefore, when you want to change the
one lane unused, please tap “Clear” button.
After that, the information such as “ASSY”
or “Program Name” becomes blank.
<Each Program Name>
The “Board Name” of each lane is displayed.
When the production is performed with in only one
lane, the board program is switched to the file of
this item.
<Board File Name>
When the “ASSY” of both lanes are input, the file name of the combined board data is displayed.
The combined board data is searched by the “Board Name” of both lanes. And it is displayed
when target board data was found.
If nothing is displayed in this item though the “ASSY” of both lanes is input, there is not the file to
change. In this condition, if OK button is tapped, an error message “Ea25690:Board data un-
registering error” is displayed.
<Note>
* There is no change in “Program List”.
* The “Board Name” corresponding to the “ASSY” and “Surface Info” is searched in the program list. Then the
combined program including the “Board Name” of both lanes is searched, and the program change is performed.
* “Lane” is added to KANBAN barcode. Please prepare the barcode as appropriate.
<Explanation of screen>
5. About Automatic Program Change-Over (Option)
MDOC
-
SOFT50073
27
5. About Automatic Program Change-Over (Option)
• BOARD ID
<Operation Procedure>
There is no change in operation procedure.
<Other>
In “Select Scanner” combo box at [Machine] - [Machine Information] - [Option
Setting] - [Scanner Setting], “Board Top (Lane2)” and “Board Bottom (Lane2)”
are selectable.
<Details of machine sequence>
By the “ASSY” of the board that arrived at the upper machine exit position, the
suitable board data are searched automatically.
At the following page, search direction is illustrated with examples.