ASM贴片机CPP头半年保养.pdf - 第18页

5 6-monthly CPP Lubricate the Z-axis support roller 1 min 2 / 2 CAUTION!Refer to safety instructions in user manual before commencing Mainten- ance NOTICE! ESD guidelines are to be followed Tool: T22, T25 Wear Part: Con…

5 6-monthly CPP Lubricate the Z-axis support roller 1 min 1 / 2

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T22, T25

Wear Part: Consumables:

C12

1 Put the front plate flat on the table with the

race way pointing up.

2 Only required for heads with a service

hole at the inside of the front plate. For all

other heads skip this task.

3 Prepare the multipette. See appendix

"Prepare the multipette.

4 Turn the wheel and adjust 1 µl. 5 For proper lubrication press the Z-Axis to

the upper stop to move the bearing below

the service hole.

6 Insert the combitip into the service hole

and apply 1 x 1 μl.

5 6-monthly CPP Lubricate the Z-axis support roller 1 min 2 / 2

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T22, T25

Wear Part: Consumables:

C12

7 Move the Z-axis 5 times up and down. 8 Clean up the multipette. See appendix

"Clean-up the multipette".

6 6-monthly CPP Clean / lubricate the Z-axis linear guide 4 min 1 / 2

CAUTION!Refer to safety instructions in user manual before commencing Mainten-

ance

NOTICE! ESD guidelines are to be followed Tool:

T12, T22, T23

Wear Part: Consumables:

C10 , C22

1 Prepare the multipette. See appendix

"Prepare the multipette.

2 Turn the wheel and adjust 4 µl. 3 Put the front plate flat on the table with the

race way pointing down.

4 Loosen the 3 screws and remove the

plastic cover from the Z-axis housing.

5 Move the Z-axis out and clean the mov-

able part on both sides at the bottom.

6 Move the Z-axis in and clean the fixed part

on both sides at the bottom.