ASM贴片机CPP头半年保养.pdf - 第45页
16 6-monthly CPP Replace the filter discs 3 min 1 / 2 CAUTION!Refer to safety instructions in user manual before commencing Mainten- ance NOTICE! ESD guidelines are to be followed Tool: T21, T37, T47 Wear Part: W7, W16 …
15 6-monthly CPP Lubricate the star bearing 3 min 2 / 2
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T12, T21, T22, T26, T29
Wear Part:
W16
Consumables:
C11
7 Turn the star by one segment (30 de-
grees).
8 Repeat step 6 to 7 for all other segments
for two full star rotations.
9 Mount the lubrication application tool with
the stopper at the side of the star motor.
10 Turn the star full 3 rotations. Lubricator
has to move up and down slightly. Then
remove lubricator.
11 Insert the grub screw. 12 Clean up the multipette. See appendix
"Clean-up the multipette"
16 6-monthly CPP Replace the filter discs 3 min 1 / 2
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T21, T37, T47
Wear Part:
W7, W16
Consumables:
1 Proceed with the head stand flat on the
table.
2 Remove all nozzles. 3 NEVER use a needle or a pointed tweez-
ers!
4 Remove the outer rubber tip. 5 Pull the inner plastic part out of the DP
drive.
6 Fit the new filter disc with your fingers and
press it in position until it engages audibly
using a plain tool.
16 6-monthly CPP Replace the filter discs 3 min 2 / 2
CAUTION!Refer to safety instructions in user manual before commencing Mainten-
ance
NOTICE! ESD guidelines are to be followed Tool:
T21, T37, T47
Wear Part:
W7, W16
Consumables:
7 Repeat step 4 to 6 for all segments. 8 Mount all nozzles.