00196845-02_AI_Vakuumpumpe_SXDX4_X-Serie-S_de_en.pdf - 第118页
Maintenance Maintenance Tasks for C&P20/A/M Head 4.2.1 Checkin g/Replacing th e Vacuum-Conducting Parts 118 Vacuum Pump Vakuumpumpe
Maintenance
4.2.1 Checking/Replacing the Vacuum-Conducting Parts Maintenance Tasks for C&P20/A/M Head
Vacuum Pump Vakuumpumpe 117
Checking the Reflecting Rings (for Vacuum Pump Operation)
Checking the holding circuit (for compressed air operation)
► Fit the holding circuit and silencer again by following the above instructions in reverse order. This
task must be carried out by authorized personnel. For removal and installation details, read the ser-
vice manual for your machine. Also observe the following instructions:
► Dismantle the reflecting ring. Loosen the screw fas-
tening the cover and remove the cover, together with
the reflecting ring.
► Check the sealing disk and the O-ring on the reflect-
ing ring for contamination and damage and replace
this if necessary.
Tighten the three fastening screws with a torque of
25+5 Ncm.
Hand-tighten the screw fastening the cover.
► Dismantle the vacuum distributor holding circuit.
► Only loosen the three protruding fastening screws on
the holding circuit and remove the holding circuit.
► Check the seat of the holding circuit (1) for dirt.
► Clean the seat with a lint-free cloth, if required.
► Check the holding circuit (2) and the seal (3) for dirt
and damage. If heavily soiled or damaged, replace
the holding circuit with a new one.
► Clean the holding circuit with compressed air. Make
sure that no dirt gets into the Venturi nozzles (4).
CAUTION
Installation instructions
► During fitting, make sure that the centering pin is inserted into the opposite hole in the seat
of the holding circuit, otherwise the holding circuit could be fitted at an incorrect angle (twist-
ed by 120 degrees).
► Make sure that the seal is inserted correctly!
► Tighten the three fastening screws of the holding circuit with 25+5 Ncm.
► Insert the silencer once more and screw it in place. The screw may only be tightened "hand-
tight".
Maintenance
Maintenance Tasks for C&P20/A/M Head 4.2.1 Checking/Replacing the Vacuum-Conducting Parts
118 Vacuum Pump Vakuumpumpe
Appendix
Arrangement of Vacuum Pumps and Distributors
Vacuum Pump Vakuumpumpe 119
5
5 Appendix
Appendix
5.1
5.1 Arrangement of Vacuum Pumps and Distributors
Arrangement of Vacuum Pumps and Distributors
SX4/DX4