SM482PLUS_Maintenance(Eng_Ver2.7).pdf - 第70页
Mon thly Inspe ction Chap ter 5 Multi -Func tional Placer SM482PLUS Maintenance Handbo ok 5-1 7 Cleaning and apply grease, lubricating the conveyor LM guide, Lead screw Step 6 . Ap ply gre ase to t he LM G uid e Rail th …
Monthly Inspection
Chapter 5
Multi-Functional Placer
SM482PLUS Maintenance Handbook
5-16
Cleaning and apply grease, lubricating the conveyor LM guide, Lead screw
Monthly Inspection
Step 4.
Remove dust and foreign material from the Work Station
and Exit Station, as well as the Lead Screw and LM Guide
Rail of the Entry Station using an ultra-fine cloth.
P C B O U T
P C B I N
Step 5.
Apply grease to the Lead Screw using a flat brush.
(GREASE: GADUS S2 V220-2)
P C B O U T
P C B I N
Monthly Inspection
Chapter 5
Multi-Functional Placer
SM482PLUS Maintenance Handbook
5-17
Cleaning and apply grease, lubricating the conveyor LM guide, Lead screw
Step 6.
Apply grease to the LM Guide Rail through a nipple
using a lubricator. (GREASE: GADUS S2 V220-2)
P C B O U T
P C B I N
B
A
BA
Caution
The designated grease must be applied using the designated
lubricator in the designated manner. Other lubricating methods are
unacceptable. When you Lubricate the Grease a large amount of
equipment, you can Grease leaves spilled in LM Guide Rail.
Caution
If the machine's operating environment is harsh, check its lubrication
status frequently.
Monthly Inspection
Chapter 5
Multi-Functional Placer
SM482PLUS Maintenance Handbook
5-18
Cleaning and apply grease, lubricating the conveyor LM guide, Lead screw
Monthly Inspection
Step 7.
Adjust the width of conveyor from the Min.to the Max. 3
or 4 times so that the grease can be properly distributed
throughout the whole section
1
2
3
①Select the <PCB Edit> Menu
②Select the <Borad> Submenu
③Enter minimum size in the Y direction in the <7. Board Size> group and
then click the <Conv.Width> Button. And Enter 200 (maximum size in the Y
direction) in the <7. Board Size> group and then click the <Conv.Width> Button
Step 8.
Release the emergency stop as described in “Releasing
‘Emergency Stop’ mode” on page 1-6 and perform the
operation again.