TR7600 SIII_Series_Maintenance_en_v_2_0_3.pdf - 第43页

Test Research, Inc. TR7600 SII I Series User G uide – Maintenance 33 Figure 53 : Large Grease Pump 4) Grease Figure 54: Grease Exa mple Location of Grease Nipples 7.1.2 1) There are a total of 13 grease nipples on the u …

Test Research, Inc.

32 TR7600 SIII Series User Guide – Maintenance

7 Q

UARTERLY

AINTENANCE

Warning: Except for the parts specifically mentioned, the power

MUST be turned off during maintenance. Failure to do so may cause

mechanical or electrical damage.

Besides the daily, weekly and monthly maintenance activities, users also need to perform

maintenance activities discussed below during quarterly maintenance.

7.1 Clean and Lubricate X-Y Tables

NOTE: In order not to damage the mechanical units and to prolong the

lifespan of the mechanical units, use the grease pump and grease when

maintaining the ball screw and the linear guide way.

Before performing this operation, users must ensure that:

1) System’s power is turned off.

2) Emergency stop is enabled. This can ensure the safety of users when the power is

turned on again.

Tools

7.1.1

1) Screwdriver: about 10 cm length.

2) Soft Cleaning Cloth

3) Grease Pump

Figure 52: Small Grease Pump

Test Research, Inc.

TR7600 SIII Series User Guide – Maintenance 33

Figure 53: Large Grease Pump

4) Grease

Figure 54: Grease Example

Location of Grease Nipples 7.1.2

1) There are a total of 13 grease nipples on the upper X Y table.

Figure 55: Locations of grease nipples of the upper table

Test Research, Inc.

34 TR7600 SIII Series User Guide – Maintenance

a) There are two grease nipples on the left and right-X-axis respectively.

Figure 56: Upper X-Y Table/Locations of left-X-axis grease

nipples

b) There is a grease nipple at the front and back-right Y-axis, respectively.

Figure 57: Upper X-Y Table/Locations of front-right-Y-axis

grease nipples