00194086-01.pdf - 第40页

2 Operational safety User Manual SIPLACE CS 2.4 Safety instru ctions for operating the mac hine Software Version SR.408.xx03/2006 US Edition 40 The feede rs are lab eled as sho wn belo w: W ARNING FIRE HAZARD 2 Æ Check a…

User Manual SIPLACE CS 2 Operational safety

Software Version SR.408.xx 03/2006 US Edition 2.4 Safety instructions for operating the machine

2.4.6 Safety instructions for processing capacitors based on powdered metal

There is a risk associated with processing capacitors based on powdered metal (e.g. tantalum).

The risk is that

– an exothermic reaction, i.e. a sudden build-up of heat, may occur, if these components are

damaged. If the ambient conditions are unfavorable, and depending on the capacitance, this

buildup of heat can cause damage.

– This effect can occur when these components are cut.

Please contact your suppliers to clarify whether the components that you handle are affected.

In extremely rare cases, this risk can occur in the tape cutter of SIPLACE machines, with the

remote possibility of causing a smoldering fire in the waste tape.

The ambient conditions are unfavorable if:

(1) The components remain on the tape while the set tape cycle is checked (since the operator

can cycle the feeder onward without removing components during this check).

(2) The components remain on the tape, e.g. due to a tear in the cover foil.

(3) The components remain on the tape, and the components or tape do not conform to the

specification, thus increasing the pickup error rate.

Please follow the instructions given below to minimize the risk when placing capacitors based on

powdered metal.

(1) If the component tape is cycled onward manually, the operator must remove any components

remaining in the tape pocket.

(2) If the cover foil tears, the operator must remove any components remaining on the tape.

WARNING 2

To avoid the risk, it is essential to use only feeders that have been approved for placing such com-

ponents, namely:

for model C/D item no.: 00141118-01

for model E item no.: 00141117-01 2

2 Operational safety User Manual SIPLACE CS

2.4 Safety instructions for operating the machine Software Version SR.408.xx03/2006 US Edition

The feeders are labeled as shown below:

WARNING FIRE HAZARD 2

Æ Check and empty the waste tape container every hour.

Æ Only empty the waste tape container into suitable collection containers because of the risk of

fire. These containers must not be set up inside buildings.

User Manual SIPLACE CS 2 Operational safety

Software Version SR.408.xx 03/2006 US Edition 2.5 Safety equipment

2.5 Safety equipment

2.5.1 Protective covers

Fig. 2.5 - 1 Safety equipment in the placement machine

(1) Cover and guard on the input belt

(2) Safety panels, right-hand side

(3) Protective cover

(4) Cover and guard on the output conveyor

(5) Protective cover

(6) Safety panels, left-hand side