SOM-1613-002.pdf - 第15页
14 Tg0780-PM-SO 0209-001 7. "Origin/Signal Info." T ab When the ''Origin/Signal Info.'' tab is pressed in the ''AUT O OPN.'' win- dow (submenu), the following tab sheet a…
13 Tg0780-PM-SO
*2 Zero All
It is indicated whether or not all devices are zeroed.
"-----" : All devices are not zeroed.
"Origin" : All devices are zeroed.
*3 [Select AII] Button
When this button is pressed, all devices (possible to be returned
to their origins) are selected and the corresponding buttons turn
yellow.
The [Select All] button cannot be used to select "L Con-
veyor Width", "R Conveyor Width", "X/Y Table Chute
Width", "P.C.B. Support Pins Up/Down" and “P.C.B. lo-
cate lever”.
*4 [Cancel All] Button
When this button is pressed, the selection of all devices is can-
celed.
*5 Control SW
When the [ENABLE] button on the front operation panel is pressed
in 2 seconds after a device (s) to be zeroed is selected and the
[ON] button (entitled "MOVE") is pressed, the device is zeroed.
(a) After the zeroing operation is completed, "Origin"
appears in the box on the right side of the corre-
sponding button.
(b) When the current position is being managed or
indefinite, "---" appears in the box.
(c) When a head is bypassed, "Bypass" appears in the
corresponding box.
0209-001
6. Zeroing Operation
Note
Note
14 Tg0780-PM-SO0209-001
7. "Origin/Signal Info." Tab
When the ''Origin/Signal Info.'' tab is pressed in the ''AUTO OPN.'' win-
dow (submenu), the following tab sheet appears inside the window.
*1 Origin Monitor
It is indicated whether or not each device is zeroed.
The devices located at their origins are marked with ''z''
The origin information is not displayed while the machine is
running.
When zeroing operation is started, this tab sheet
appears automatically.
Fig. 6
7. "Origin/Signal Info." Tab
Note
15 Tg0780-PM-SO0209-001
8. Maintenance
8. Maintenance
8.1 Maintenance Spots
8.2 Inspection
Table 3
8.3 Lubrication
Lubrication Spots
Linear Guide Rail
Ball Screw
(Chute and Conveyor Widths)
Lubrication
Frequency
6 months
6 months
Inspection Item
Linear Guide Rail
Ball Screw
Inspection
Frequency
6 months
6 months
Checking and Countermeasures
• Wipe off dirt and dust with a rag.
• Wipe off dirt and dust with a rag.
Grease or Oil
• DAPHNE EPONEX GREASE No. 1
• DAPHNE EPONEX GREASE No. 1
Table 4
Fig. 7
Fibers of a cloth might cause machine breakdown, if
left on the machine after cleaning using a cloth. Use a
type of cloth leaving fibers as less as possible.
CAUTION
Ball Screw
Linear Guide
(Front Side of Machine)