SOM-1619-001.pdf - 第12页
12 Tg0590-PM-SO (9) Indicate the step to be checked using the vertical scroll bar on the step data display section and select the step. When the [Desig Step] button *6 is pressed on the lower left of the step display , t…
11 Tg0590-PM-SO0301-002
4. PCB Origin Offset Teach
(5) Check the setting of Teach Point. Press the [TEACH] button *5
and then within two seconds, press the [ENABLE] button on the
operation panel. The teaching operation will be performed.
(6) Manipulate the pointing device to accommodate the component
outer shape image within the window size to the PCB pattern
entered in the recognition memory image.
Operation of Pointing Device
Joy Stick : Movement of the X/Y table (PCB
Pattern)
Right Click : Enlargement of Image
Left Click : Reduction of Image
Click on the Right and Left at the same time
: Positioning Completion
When the positioning is completed, the new PCB origin offset is
displayed in the "Teach Result (X, Y)" box *2.
(7) When the new PCB origin offset is temporarily entered, press the
[Temp Entry] button *3.
The new PCB origin offset is temporarily written in the temporary
file.
(a) Temporarily entering new PCB Origin Offset saves
the temporary file in the data for the operation and
pattern program file, but does not overwrite the
original file.
(b) Cancellation of temporarily entered data is available
during the temporary enter operation. To cancel,
press the [Cancel] button *9.
(8) Check the temporarily entered data using the placement step
operation.
Press the [Place Pos] button *1.
12 Tg0590-PM-SO
(9) Indicate the step to be checked using the vertical scroll bar on
the step data display section and select the step.
When the [Desig Step] button *6 is pressed on the lower
left of the step display, the step can be entered directly
using the ten-key.
(10) Select the [Move to Teach Pt] button *4 and then the "Move"
[ON] button *11. Within two seconds, press the [ENABLE]
button on the operation panel.
The X/Y table will move to the selected step position.
(11) When the new PCB origin offset is entered formally, press the
[End] button *10.
The "Is data saved temporarily ?" window is displayed.
Changing the Current Pattern Program Data (Save)
When the [YES] button is pressed in the "Is data saved
temporarily ?" window, the "Overwrite data. Is it OK ?"
window is displayed.
Press the [YES] button, then the temporarily entered data
about the PCB origin offset will be overwritten.
Fig. 3 "Confirmation to Saving" Window
0301-002
4. PCB Origin Offset Teach
13 Tg0590-PM-SO
Maintaining the Current Pattern Program Data (Save As)
When the [NO] button is pressed in the "Is data saved tem-
porarily ?" window, the "File Name Entry" window is indi-
cated.
Enter the new file name and press the [SET] button.
The temporarily saved PCB origin offset data is saved with a
newly entered file name.
Deleting the Teach Data (All Teach Data Delete)
Press the [NO] button in the "Is data saved temporarily ?"
window.
0301-001
4. PCB Origin Offset Teach