Infinity DI.pdf - 第51页
2.4 Infinity Dual Imag e Manual Chapter Issue 3 Jan 01 INFINITY OPERATOR SET U P Duing a Print If during a print run the ba r code is not recognised, the print run is suspended. Softk eys F1 Continue , F7 Swap Pr oduct a…
Chapter Issue 3 Jan 01 Infinity Dual Image Manual 2.3
INFINITY
OPERATOR
SET UP
SET UP
Load Products If a bar code reader is used to determine the product identity, product and remote
bar codes need to be set up in Set Prefs before proceeding, see - Adjustments
and Settings.
To assign a product file to ‘Product A’ and ‘Product B’, from the menu bar,
follow the steps below:
1. Select Setup (F6)
2. Select Load Data (F2)
The screen below is displayed:
3. Using the Next and Previous (F4, and F5) keys, highlight Product A.
4. Select Load.
A list of all product files stored on the machine is displayed.
5. Using the Left, Right, Up and Down (F4, F5, F6, and F7) keys, highlight
the required file.
6. Select Load.
The product file has been selected. Repeat the steps above to select a product file
to correspond to Product B.
2.4 Infinity Dual Image Manual Chapter Issue 3 Jan 01
INFINITY
OPERATOR
SET UP
Duing a Print If during a print run the bar code is not recognised, the print run is suspended.
Softkeys F1 Continue, F7 Swap Product and F8 Abort are displayed (all others
are blank). The folowing message is displayed in the message prompt area:
Figure 2-1 Bar Code Read Error Prompt
The *3* (example) represents what the scanner has read, the interpreted "3"
represents what the software interprets the bar code as. Selecting abort termi-
nates the print run and the product is ejected to the output conveyor for removal.
If swap product is selected the machine swaps the current product for the other
product and printing continues with the new product. If continue is selected the
machine continues printing with the current product.
Where the Product Sensor is fitted, the product selection screen is displayed as:
Adjust Product File Product A or Product B process parameters can be adjusted as follows:
NOTE
Product ‘A’ is assigned as the front image and Product ‘B’ the rear image as
described throughout this manual.
1. Select Adjust (F5 function key).
2. The Product Selection page is displayed.
3. Select the product to edit from the list.
4. Select the process parameter(s) to edit.
Chapter Issue 3 Jan 01 Infinity Dual Image Manual 2.5
INFINITY
OPERATOR
SET UP
5. Select Exit when complete.