Infinity DI.pdf - 第59页

2.12 Infinity Dual Imag e Manual Chapter Issue 3 Jan 01 INFINITY OPERATOR TOOLING Maximum Dimensions The figure belo w describes the maximum useable dimensions for print in the dual image mode. T ooling need only be plac…

Chapter Issue 3 Jan 01 Infinity Dual Image Manual 2.11

INFINITY

OPERATOR

TOOLING

TOOLING The following board support tooling options are available for use with the

printer:

• Magnetic Support Pillars

• Vacuum Box Tooling

• MultiFlex Tooling

• Dedicated Tooling Plate

• AutoFlex Tooling

• Fine Pitch AutoFlex

• ProFlow Stencil Support

Details of tooling options are given in the Board Support Tooling chapter of the

Infinity Technical Reference Manual.

When setting tooling for two images, the screen images may be for entirely

different products or for a single product printed both sides. In both cases any

tooling placed on the table must be positioned to give support for both images.

Hence, if tooling is placed for a first print run and the board is then flipped over

to be printed on the underside, the board is loaded to the same location for both

prints and tooling placed must accommodate both prints.

Features such as components, must not have tooling pins or support structures

placed for the first print run that would infringe upon the components on the

second print run.

Where vacuum tooling, for example a dedicated tooling plate is used, tooling

support must be given to underside components and first print features without

impairing the vacuum. If the second run had board features such as through

holes, vacuum would be impaired. The tooling must account for such features.

CAUTION

CAMERA DAMAGE. Do not leave any unused tooling on the rising table

in the area behind the rear rail. If any object is left on the rising table

outside the board printing area, it could collide with the camera carriage as

the rising table moves to print height.

2.12 Infinity Dual Image Manual Chapter Issue 3 Jan 01

INFINITY

OPERATOR

TOOLING

Maximum

Dimensions

The figure below describes the maximum useable dimensions for print in the

dual image mode. Tooling need only be placed within these boundaries

Chapter Issue 3 Sep 01 Infinity Dual Image Manual 3.1

INFINITY

A3 DRAWINGS

LISTING

CHAPTER 3 A3 DRAWINGS

LISTING

Description Drawing No. Sheets Issue

State

Mechanical

Infinity Dual Image Screen Ski’s 168001 102

Frame Assembly 168107 202

Electrical

Variable Time Sensor Latch Switch 142771 1 09

288 Screen Load Circuit 167002 2 01

Typhoon Board Handling Circuit

155546