QP132三级参考手册.pdf.pdf - 第107页
8.2 T raining Evaluation Circle the most appropriate answer from the list below. (1) To adjust pallet 10 mm shift: a. a block jig is required. b. a dial gauge is required. c. Both a and b above. (2) To adjust pallet pass…
8.1.8 Pallet Detection Sensor
1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y04A P.IN PLT FWD to move the pallet from the return
conveyor stopper to the IN- pallet loader.
2. The pallet detection sensor lies diagonally across the pallet. There is no
sensitivity volume and it is not possible to adjust vertically. Adjust the
sensor angle by the mounting bolts. Move the pallet manually and check
the sensor reaction.
Chapter 8 8.1 In Shifter Adjustment
Edition 1.1 8-8 QP-132 Level 3 Tutorial
8.2 Training Evaluation
Circle the most appropriate answer from the list below.
(1) To adjust pallet 10 mm shift:
a. a block jig is required.
b. a dial gauge is required.
c. Both a and b above.
(2) To adjust pallet pass through check sensor:
a. advance the 10 mm shift.
b. place a pallet against the stopper.
c. Both a and b above.
(3) To adjust the sensitivy of pallet arrival check sensor:
a. a jig is used.
b. a pallet is used.
c. Both a and b above.
(4) To adjust pallet shift, set the 10 mm shift to:
a. the forward position.
b. the retract position.
c. The position does not matter.
(5) Pallet Shift Forward and Backward End Sensor sensitivity is adjusted by:
a. the amp.
b. the position of the sensor.
c. the angle of the sensor.
Chapter 8 8.2 Training Evaluation
Edition 1.0 8-9 QP-132 Level 3 Tutorial
Notes:
Chapter 8 8.2 Training Evaluation
Edition 1.0 8-10 QP-132 Level 3 Tutorial