QP132三级参考手册.pdf.pdf - 第114页
9.1.4 Pallet Shift Forward and Backward End Sensors 1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT] and turn on Y066P. OUT PLT FWD to advance the shift. 2. Find the position where the sensor turns on and of…
4. Place the pallet and move the shift cylinder forward and backward to
check for any interference.
9.1.3 Pallet Shift
1. Adjust the pallet pushing jaw using the set screw. The jaw must be
parallel to the bracket when the cylinder is at the backward end position.
2. Adjust the forward and backward speed controller to:
Cylinder Forward : Fully open
Cylinder Backward : Fully open
Note: The Speed controllers are attached to the solenoid valve at the OUT- pallet loader box.
(M/C front)
QP132T9004
10 mm
shifted pos.
10 mm shifted pos.
Adjust so they
just contact
OUT prevention
stopper
16-inch pallet
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-4 QP-132 Level 3 Tutorial
9.1.4 Pallet Shift Forward and Backward End Sensors
1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y066P. OUT PLT FWD to advance the shift.
2. Find the position where the sensor turns on and off.
3. Move the sensor 1 mm to ON direction.
4. Turn on Y067 P.OUT PLT BWD and adjust the sensor position in same
manner as forward position.
QP132T9005
Cylinder
Pallet guide rail
Parallel
Set screw
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-5 QP-132 Level 3 Tutorial
Notes:
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-6 QP-132 Level 3 Tutorial