QP132三级参考手册.pdf.pdf - 第133页
Notes: Chapter 1 1 1 1.1 P AM Edition 1.1 11-6 QP-132 Level 3 T utorial
11.1.2 Nozzle E and F
1. Enter zero for MQ3ANEOX [PM1] Nozzle _ E Offset X,Y.
2. Enter the value of MQ3ANDOX [PM1] Nozzle _ D Offset X,Y to
MQ3ANFOX [PM1] Nozzle _ F Offset X,Y.
3. Enter the value of MQ3ACOAX [PM1] Center offset A_X to MQ3ACOEX
[PM1] Center Offset E_X.
4. Enter the value of MQ3ACOAY [PM1] Center offset A_Y to MQ3ACOEY
[PM1] Center Offset E_Y.
5. Enter the value of MQ3ACODX [PM1] Center offset D_X to MQ3ACOEX
[PM1] Center Offset F_X.
6. Enter the value of MQ3ACODY [PM1] Center offset D_Y to MQ3ACOEY
[PM1] Center Offset F_Y.
7. Use program PAM_EF. PGO.
8. Repeat procedures 3 ~ 7 and 12 ~ 34 of Nozzle A, B, C and D.
Note: It is not necessary to measure the T-Mark.
9. Copy the sequence on the measured data to the QP132_1Cpk.xls for the
offset calculation.
10. Repeat the procedure 36 ~ 40 of Nozzle A, B, C and D.
Chapter 11 11.1 PAM
Edition 1.1 11-5 QP-132 Level 3 Tutorial
Notes:
Chapter 11 11.1 PAM
Edition 1.1 11-6 QP-132 Level 3 Tutorial
11.2 Training Evaluation
Circle the most appropriate answer from the list below.
(1) Before PAM, machine should be warmed up for:
a. more than 1 hour.
b. more than 3 hours.
c. more than 5 hours.
(2) Which is the correct order of performing PAM?
a. Nozzle A, B, C and D then E and F
b. Nozzle E and F then A, B, C and D
c. All the nozzles at the same time
(3) Center Offset is applied to:
a. nozzle holder center.
b. nozzle holder center and Camera center.
c. nozzle holder center and Program origin.
(4) Which nozzle is used for PAM?
a. 0.7 mm
b. 1.0 mm
c. 1.3 mm
Chapter 11 11.2 Training Evaluation
Edition 1.0 11-7 QP-132 Level 3 Tutorial