QP132三级参考手册.pdf.pdf - 第115页
Notes: Chapter 9 9.1 Out Shifter Adjustment Edition 1.1 9-6 QP-132 Level 3 T utorial
9.1.4 Pallet Shift Forward and Backward End Sensors
1. Press [SET] → [MANUAL] → [I/O] → [STANDARD I/O] → [OUTPUT]
and turn on Y066P. OUT PLT FWD to advance the shift.
2. Find the position where the sensor turns on and off.
3. Move the sensor 1 mm to ON direction.
4. Turn on Y067 P.OUT PLT BWD and adjust the sensor position in same
manner as forward position.
QP132T9005
Cylinder
Pallet guide rail
Parallel
Set screw
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-5 QP-132 Level 3 Tutorial
Notes:
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-6 QP-132 Level 3 Tutorial
9.2 Training Evaluation
Circle the most appropriate answer from the list below.
(1) To adjust pallet 10 mm shift:
a. a block jig is required.
b. a dial gauge is required.
c. Both a and b above .
(2) To adjust the pallet stopper:
a. an 8 inch pallet is required.
b. a 16 inch pallet is required.
c. Both a and b above.
(3) The pallet shift jaw must be parallel to the bracket when the cylinder is
set at:
a. a backward position.
b. a forward position.
c. the middle.
(4) Adjust the Pallet Shift Forward and Backward End Sensors to:
a. 1 mm from the edge of the cylinder.
b. 1 mm outside of the on and off position.
c. 1 mm inside of the on and off position.
(5) Pallet Detection Sensor sensitivity is adjusted by:
a. the amp.
b. the position of the sensor.
c. the angle of the sensor.
Chapter 9 9.2 Training Evaluation
Edition 1.0 9-7 QP-132 Level 3 Tutorial