QP132三级参考手册.pdf.pdf - 第116页
9.2 T raining Evaluation Circle the most appropriate answer from the list below. (1) To adjust pallet 10 mm shift: a. a block jig is required. b. a dial gauge is required. c. Both a and b above . (2) To adjust the pallet…
Notes:
Chapter 9 9.1 Out Shifter Adjustment
Edition 1.1 9-6 QP-132 Level 3 Tutorial
9.2 Training Evaluation
Circle the most appropriate answer from the list below.
(1) To adjust pallet 10 mm shift:
a. a block jig is required.
b. a dial gauge is required.
c. Both a and b above .
(2) To adjust the pallet stopper:
a. an 8 inch pallet is required.
b. a 16 inch pallet is required.
c. Both a and b above.
(3) The pallet shift jaw must be parallel to the bracket when the cylinder is
set at:
a. a backward position.
b. a forward position.
c. the middle.
(4) Adjust the Pallet Shift Forward and Backward End Sensors to:
a. 1 mm from the edge of the cylinder.
b. 1 mm outside of the on and off position.
c. 1 mm inside of the on and off position.
(5) Pallet Detection Sensor sensitivity is adjusted by:
a. the amp.
b. the position of the sensor.
c. the angle of the sensor.
Chapter 9 9.2 Training Evaluation
Edition 1.0 9-7 QP-132 Level 3 Tutorial
Notes:
Chapter 9 9.2 Training Evaluation
Edition 1.0 9-8 QP-132 Level 3 Tutorial