5M-1751-004w_G5S.pdf - 第12页
Safety Precautions Safe-3 1OM-1751 1303-001 3. Common Precautionary Items 3. Common Precautionary Items Precautions before Use Only a well-trained person should operate the machine. Do not allow any untrained person to…
Safety Precautions
Safe-2
1OM-1751
1303-001
2. General Safety Instructions
2. General Safety Instructions
Basic Precautions
Before operating this machine, make sure to read the instruction manual carefully for
correct operations.
Please keep the instruction manual in a safe place within reach.
Follow the instructions in the instruction manual for correct handling of the machine.
Make sure to fully understand the contents of the safety instructions in this instruction
manual and follow these instructions.
Pay special attention to the precautionary items labeled on this machine or described
in the instruction manual and make sure to follow them. If the precautionary items are
ignored, it will result in personal injury or property damage (damage to the machine).
Make sure to follow the operational instructions for this machine described in this
instruction manual.
Never modify the machine or use any part other than the specied ones for the machine.
Make sure not to use the machine with its safety devices detached. Doing so may cause
personal injury.
Do not perform any operations other than those described in the instruction manual.
Whenever a problem arises, regarding the machine operations, performance, etc., please
contact the marketing department or sales agency of Yamaha Motor Co., Ltd. for the
solution.
Although the precautionary items have been reviewed repeatedly, an incident far beyond
our expectation may occur.
Not only follow the precautionary instructions described in the instruction manual but
also try to handle the machine carefully at your discretion all the time.
Be sure to strictly keep the above-mentioned instructions. Otherwise, not only wrong
operations of the machine but also personal injury will result.
Safety Precautions
Safe-3
1OM-1751
1303-001
3. Common Precautionary Items
3. Common Precautionary Items
Precautions before Use
Only a well-trained person should operate the machine.
Do not allow any untrained person to operate the machine.
Mishandling of the machine can cause a serious accident.
Before operating the machine, please read the instruction manual carefully for correct
operations.
Although the precautionary items have been reviewed repeatedly, an incident far beyond
our expectation may occur.
Not only follow the precautionary instructions described in the instruction manual but
also try to handle the machine carefully at your discretion all the time.
Conrm that no covers are disengaged before operating the machine.
If the machine is used with its cover(s) being detached, a serious accident may
occur.
Be sure to attach them in place.
Make certain that no person or object comes in contact with the moving
mechanisms of the machine. Then, check safety and power up the machine to
start operation.
Do not start the machine unless those working in the immediate area of the
machine are aware of hazards from moving parts.
Those who wear implanted pacemakers are not allowed to work inside the
machine.
This machine uses strong permanent magnets in the moving areas of the X/Y
beams.
The pacemaker may be aected by the magnetism and a serious accident will
result.
Those who wear implanted pacemakers are not allowed to handle the tape
feeders.
The pacemaker may be aected by the magnetism and a serious accident will
result.
Safety Precautions
Safe-4
1OM-1751
1303-001
3. Common Precautionary Items
If the bank feeder change cart is not set, a clearance will be left at the feeder
setting area and the operator will be exposed to danger.
Be sure to use the machine with the bank feeder change cart being connected.
Even after the [EMERGENCY STOP] switch is pressed, note that electrical
power is supplied to the control device.
To shutdown the power to all loads, set the power breaker to "OFF".
When "Emergency Switch O" is required, it must be prepared outside the machine on
the customer side.
Emergency Switch Stop : Emergency Interception of Controlled Load Power Sources
Emergency Switch O : Emergency Interception of All Load Power Sources
In principle, the overall operation of the machine including the button operations
on the operation panel and the touch screen must be controlled by only one
person.
If there are more than one, ensure good communication by giving loud verbal
instructions.
Before starting the automatic operation, check carefully that there is no person around
the machine (especially on the other side of the machine operation). Make sure that no
objects (tools, parts, etc.) are left behind.
Data may become unavailable due to breakdown or mishandling of the machine.
It is strongly recommended that the hard disk data be periodically backed up with the
network terminal (option).
Do not use the oppy disk drive in the control box. The drive is provided only for the
authorized maintenance personnel.
Be sure to strictly keep the above-mentioned instructions. Otherwise, not only wrong
operations of the machine but also personal injury will result.