YS24X_Mainte_E.pdf - 第135页

5-9 5 Lubrication points and schedule 2.5 Z-axis (Spline shaft) n NOTE Basically, the lubricating the spline shaft (Z-axis) is not required. However , the grease on the spline shaft sur face is removed by touching with h…

5-8

Lubrication points and schedule

2.4.3. Single-lane specifications

PU-axis lubrication points

Single-lane

Grease gun:

Manual lubrication:

Ball screw

53509-L4-00

Lubrication section Lubrication point Interval Procedure

Ball screw 3 Once every 2 months Manual lubrication

5-9

Lubrication points and schedule

2.5 Z-axis (Spline shaft)

NOTE

Basically, the lubricating the spline shaft (Z-axis) is not required. However, the grease on the spline shaft surface is

removed by touching with hand or by sprinkling solvent. As a result, the spline shaft gets easily rusted. Apply the

speciﬁed grease (NSL) slightly for anti-rusting as needed.

Z-axis lubrication points

Z-axis spline shaft

Grease gun:

Manual lubrication:

53507-L4-10

Lubrication section Lubrication point Interval Procedure

Z-axis spline shaft 10 (each table) 3 months Manual lubrication (thin coat)

Chapter 6 How to replace consumable parts

Contents

1. Nozzle 6-1

1.1 Replacing the nozzle tip and spring 6-1

1.2 Replacing the nozzle O-ring 6-2

2. Nozzle leaf springs 6-3

3. Ejector unit 6-5

3.1 Replacing an ejector bit 6-5

3.2 Replacing a valve (solenoid valve) 6-6

3.3 Replacing the cleaning blow valve 6-7

4. Conveyor 6-8

4.1 Replacing the conveyor belt 6-8