DECAN_S2_Operation(ENG_Ver4.1).pdf - 第80页
Ch e ck o th e r s and r e plac e e xhaus t e d part s Chap ter 6 Advanced Chip Shooter DE CAN S2 O pe rat ion H an db ook 6-9 This Chapter describes the items for which care must be exercised while using thetape feeder …
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-8
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Checking if the feeder is properly mounted on the feeder base
Checking Feeder
Check others and replace exhausted parts
8. Checking if the feeder is properly mounted on the
feeder base
Step 1.
Check the probe pins of the feeder.
Step 2.
Secure the grip after mounting the feeder.
Step 3.
Check the LED color of the feeder.
Caution
When properly installed, the LED color is green. If the LED color is
not green even when the feeder is properly mounted, contact the
A/S center.
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-9
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Setting the pickup height of the parts
Checking Feeder
9. Setting the pickup height of the parts
- To set the pickup height of the parts, select 'PCB Edit' > 'Feeder Z Pickup' in MMI.
Check Points
ㆍ You should set the pickup height differently depending on whether
theart is fed by the paper tape reel or by the emboss tape reel.
ㆍ Please refer to the figure on the left when you set the pickup height of
the parts.
or detailed information, please refer to “1.3 Reference plan
for the z-axis height of SM tape feeder (p. 1-8)” in the SM
feeder manual.
Example
ㆍ Paper Type: 1608R -> Z
0.5
ㆍ Emboss Type: Z = -0.1
10. Operating the machine after changing the reel
When you close the reel arm after reel change, you should lift it slightly.
Slow Swing
1
2
ㆍ 12mm ~ 88mm
Check Points
The machine will operate only if you l
ft the reel arm
upwards when you close the reel hanger.
Caution
If you try to close the arm too hard, you may damage the reel
stopper.
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-10
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Checking Feeder > Precautions that need to be taken when you check the reel information
Checking Feeder
Check others and replace exhausted parts
11. Precautions that need to be taken when you check
the reel information
You should open the reel arm before you can check the reel information.
1
2
ㆍ When you check the reel information, you should open (lift) the reel arm plate
first.
Caution
If you try to move the reel arm plate sideways as shown in the
figure below, the reel arm plate may bend.