DECAN_S2_Operation(ENG_Ver4.1).pdf - 第87页
Ch e ck o th e r s and r e plac e e xhaus t e d part s Chap ter 6 Advanced Chip Shooter DE CAN S2 O pe rat ion H an db ook 6-1 6 This Chapter describes the items for which care must be exercised while using thetape feede…
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-15
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Replace exhausted parts > Change the part reel
Replace exhausted parts
Step 5.
Install and discharge the tape referring to the figure. (Install
the tape so that it passes through 'A' and 'B'.)
Step 6.
Secure the locker after closing the tape guide. (Secure the
locker referring to the following figure.)
Step 7.
Secure the feeder in the orresponding slot.
Step 8.
Secure the grip.
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-16
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Replace exhausted parts > Change the part reel
Replace exhausted parts
Check others and replace exhausted parts
Step 9.
Put the used tape and vinyl in the empty box. Cut the used
tape and vinyl at appropriate intervals with scissors to avoid
the occurrence of defective feeding.
For further details regarding part reel replacement, refer to the tape
feeder's user manual.
Check others and replace exhausted parts
Chapter 6
Advanced Chip Shooter
DECAN S2 Operation Handbook
6-17
This Chapter describes the items for which care must be exercised while
using thetape feeder as well as the method to take measures when
parts are exhausted.
Replace exhausted parts > Tape Connection Method (Paper Type)
Replace exhausted parts
2. Tape Connection Method (Paper Type)
Step 1.
Cut the end part of the tape in use and the beginning part of
the new tape by using scissors.
4mm
2mm
Step 2.
Peel off the vinyl tape on the leading end of the new tape.
Step 3.
Place the I-shape tip in the tool so that the burr is on the top.
Step 4.
Connect the tapes by manipulating the handle of the tool.