00195366-01_InstallationManual_EDM_en.pdf - 第55页

Installation Manual SIPLACE EDM Edition 11/2006 5.4.1.3 Line server Figure 19 Line servers Here you specify the list of line servers for which the application template is to apply. The names in this list must also be loc…

100%1 / 66
Installation Manual SIPLACE EDM Edition 11/2006
5.4.1.1.1 Pull mode
No additional settings can be specified for this type of data transfer between the master server and
line servers.
5.4.1.1.2 Forced pull mode
For this type of data transfer, the time after which the data preparation engineer will be notified that
no new data has been pulled for the line must be specified via “Configure”. The time is specified in
hours.
Figure 17 Forced Pull Mode configuration
5.4.1.2 Overwriting
Figure 18 Settings for overwriting object types
This is where you can select the object types to be overwritten when the data is imported to the line.
54 of 66
Installation Manual SIPLACE EDM Edition 11/2006
5.4.1.3 Line server
Figure 19 Line servers
Here you specify the list of line servers for which the application template is to apply. The names in
this list must also be located in the endPointConfig (see 5.2.3.13) of the application settings.
5.4.2 Email configuration
EDM email notification uses SMTP to distribute notifications arriving at the master server. The
following must be configured:
• The network address of the SMTP server
• The sender to be entered in the message
• A set of distribution lists
Email distribution lists make it possible to keep email traffic to a minimum and to send the emails to
precisely the person(s) responsible. A distribution list only responds to notifications from a specific
line which contain changes to specific object types.
55 of 66
Installation Manual SIPLACE EDM Edition 11/2006
Figure 20 Configuration of Email distribution lists
The storage location of the configuration file should be specified for informational purposes and
must not be changed. Direct manipulation of the configuration file should also be avoided.
5.4.2.1 Setting up a new list
A line must be selected before a new distribution list can be added. A name and a comment are
assigned to each new list.
56 of 66