M7_ServiceManual_e.pdf - 第56页
3 Mechanical Section 3-22 ■ Lubrication Poin ts for X/Y M7-3L/M7-2 L M7-3S Y-axis Linear Guide Y-axis Ball Screw X-axis Ball Screw X-axis Linear Guide X-axis Linear Guide X-axis Ball Screw Y-axis Ball Screw Y-axis Linear…
3 Mechanical Section
3-21
Lubrication
Lubrication Points
Lubricate the specified portions listed below with cotton swab soaked with lubricant.
UNIT PORTION LUBRICANT FREQ.
Ball Screw of X-axis Grease Every two weeks
Linear Guide of X-axis (Upper and Lower) Grease Every two weeks
Ball Screw of Y-axis (Right and Left) Grease Every two weeks
Linear Guide of Y-axis (Right and Left) Grease Every two weeks
Feeder Bank Plates Grease Every two weeks
Conveyor Width Adjusting Screw Grease Monthly
M7 Conveyor Guide Shaft Grease Monthly
Ball Screw of Z-axis Grease Every two weeks
Spline Shaft of Z-axis Grease Every two weeks
Linear Way of Z-axis Grease Every two weeks
Nozzle Holder Silicone Grease Monthly
Nozzle Silicone Grease Weekly
NOTE: Do not apply excessive oil/grease. This may cause oil/grease scattering when the mounter is in operation.
3 Mechanical Section
3-22
■ Lubrication Points for X/Y
M7-3L/M7-2L
M7-3S
Y-axis Linear Guide
Y-axis Ball Screw
X-axis Ball Screw
X-axis Linear Guide
X-axis Linear Guide
X-axis Ball Screw
Y-axis Ball Screw
Y-axis Linear Guide
3 Mechanical Section
3-23
M7 Grease up
X-axis Ball Screw
Ball Screw Cover ( closed )
X-axis Ball Screw
Ball Screw Cover ( open )
Beam Camera
X-axis slider
Cover window for
Bal l Screw
Grease Nipple
Ball Screw