SA_HF_intern_0194307-02_eng.pdf - 第60页

3 Serv ice Cu tter SIPL ACE HF-Ser ies Replacing the Cu tter Blades [03009259 - xx] 3-46 0019 43 07- 02 Is su e 1 1/ 2004 Copy ri gh t © 2 004 S ie m ens 4 3 5 1 4 3 2  Loosen and re move the two sc rews (1) fasteni ng …

100%1 / 76
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
Service
Cutter
3
Copyright © 2004 Siemens 00194307-02 Issue 11/2004 3-45
WARNING
There is a high risk of injury from the blades and the tape deflector.
Wear appropriately thick protective gloves!
Never reach into the cutter from below or into the empty-tape duct from above.
Make sure that no-one can injure themselves on the cutter after it has been dismantled and placed next to the
machine!
Disassembly
4
1
4
3
2
Dismantle the component trolley feed device and the cutter.
Remove the protective sheet (2) and the deflector plate (3).
Remove the cover plate (1).
Remove the caps (4) on the fastening screws.
WARNING
There is a risk of injuring yourself on the cutting edge of the blades.
For all further work, either fix the cutter to the assembly plate
with 4 hexagon socket-head screws or use screw clamps to
fasten the cutter to a sturdy, stabile table.
3
Service
Cutter
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
3-46
00194307-02 Issue 11/2004 Copyright © 2004 Siemens
4
3
5
1
4
3
2
Loosen and remove the two screws (1) fastening the stationary
blade (2).
Undo the screws fastening the left and right tape deflectors (3)
above the moveable blade.
CAUTION
Do not loosen the two Phillips screws (4)
Remove the tape deflector holder with the tape deflector (5) and
carefully place the whole unit down (with the tape deflector
facing upwards).
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
Service
Cutter
3
Copyright © 2004 Siemens 00194307-02 Issue 11/2004 3-47
3
4
1
5
4
3
2
Remove the right-hand holding-down device (1) and the left
holding-down device (2), plus the spacers below.
Use an SW 10 open-ended wrench to push against the joint (3),
while loosening the hexagon socket-head screw of the joint (4)
in the moveable blade. This may require more strength than
usual as the screws have been secured with Loctite no. 243.
Grasp both ends of the moveable blade (5) with the protective
gloves and pull it upwards and out.
Installation – Requirements
WARNING
There is a high risk of injury from the blades and the tape deflector.
Wear appropriately thick protective gloves!
Make sure all parts are clean before installing them.
The new blades are covered with a fine lubrication film. Do not use fat dissolving agents on the blades (risk of rust
film forming) or apply any additional lubrication (risk of contamination by particles sticking to the blades). This
would only impair the movement of the moveable blade.