SA_HF_intern_0194307-02_eng.pdf - 第63页
SIPL ACE HF-Ser ies Replacing the Cu tter Blades [03009259 - xx] Serv ice Cu tter 3 Copy ri ght © 200 4 S ie m ens 0019 43 07- 02 Is su e 1 1/ 2004 3-49 Installation 2 3 4 1 4 3 2 Correctly insert the moveable blad e (…
3
Service
Cutter
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
3-48
00194307-02 Issue 11/2004 Copyright © 2004 Siemens
If the new blades are not clean, carefully rub them (wear protective gloves) with a well folded, clean and dry cloth.
Do not use fat dissolving agents!
Preparation
1
6
5
4
3
2
Make sure the cutter is in the correct rotary position (see the
slant of the blade).
Check the positioning of the individual blades to one another.
Before installation, lubricate the sliding surface of the moveable
blade.
1. Stationary blade
2. Moveable blade
3. Sliding surfaces to be lubricated
4. Holding-down device
5. Spacer
6. Contact surface
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
Service
Cutter
3
Copyright © 2004 Siemens 00194307-02 Issue 11/2004 3-49
Installation
2
3
4
1
4
3
2
Correctly insert the moveable blade (1) into the cutter and shift
it along to its original installation position.
Apply Loctite no. 243 to the two M4 screws, to fasten the joint in
the moveable blade.
Insert the screws (2) into the left and right holes provided in the
moveable blade.
NOTE:
Make sure that the joint (3) can slide into the slot (= anti-twist
function) in the moveable blade without obstruction.
Use an SW 10 open-ended wrench to push against the relevant
joint(3) and then tighten both screws (2) to a torque of 2. – 3. N.
Replace the two covers (caps).
Place the two new spacers (4) to the left and right of the
moveable blade. The spacer side marked with a number must
face towards the blade.
The spacers and blades are matched !
3
Service
Cutter
SIPLACE HF-Series
Replacing the Cutter Blades [03009259-xx]
3-50
00194307-02 Issue 11/2004 Copyright © 2004 Siemens
1
2
4
1
5
4
3
2
Lubricate the contact/slide surfaces for the moveable blade, as
described in the section „Preparation“.
CAUTION
Do not lubricate the blades themselves.
Place a shim (0.5 - 1.0 mm thickness) on the left and right,
between the spacer and the front of the blade (1).
Place the previously removed holding-down device (2) onto the
new spacers.
The holding-down devices with function status 03 are
designed for use with cutters of function status -04 (= with
tape deflector).
Reinsert the tape deflector unit (3) and screw in the 4 hexagon
socket-head screws (4) by hand.
Push the spacers (with inserted shim)as far as possible in the
direction of the moveable blade. The maximum permissible gap
is 1.0 mm.
In this position, tighten the 4 screws (4) on the tape deflector
holder crosswise (tightening torque).
Remove the two shims.
Insert the new stationary blade (5) in the correct position and
screw tighten.