00194547-03.pdf - 第22页
Installation Manual Station Software Version 601.02 SP1 Edition 10/2005 22 of 82 Fig. 4-7: TouchWare Properties – Calibrate tab (example for Monitor 1) → Click the Calibrate button. An icon representing the ca libration …
Installation Manual Station Software Version 601.02 SP1 Edition 10/2005
21 of 82
Fig. 4-6: TouchWare Properties – Multiple Monitors tab (example for Monitor 2)
→ Click the number of the monitor you wish to calibrate.
→ Open the Calibrate tab.
Installation Manual Station Software Version 601.02 SP1 Edition 10/2005
22 of 82
Fig. 4-7: TouchWare Properties – Calibrate tab (example for Monitor 1)
→ Click the Calibrate button. An icon representing the calibration is shown on screen. An icon
representing a hand guides you through the calibration steps by pointing to the calibration icon
you must touch.
Fig. 4-8: Calibration icon
Installation Manual Station Software Version 601.02 SP1 Edition 10/2005
23 of 82
Notes:
Touch the calibration icon within 20 seconds, otherwise calibration is automatically
canceled.
Make sure that you are standing directly in front of the monitor.
Carry out calibration in the position (standing or seated) you normally adopt when working
at this screen.
Touch the calibration icon firmly and accurately with your fingertip.
Make sure that you to not inadvertently touch the screen with any other finger.
→ Touch the calibration icon with your finger and make sure that the yellow area is completely
covered by your finger. The message "Hold" appears around the hand icon.
→ Keep your finger on the calibration icon until the "Touch Enabled" message appears. A second
calibration icon now appears.
→ Repeat the steps described above for the second calibration icon.
A dialog box then appears asking you to test the calibration. You can carry out the calibration
again if you are not sure that you have carried it out correctly the first time.
→ Carry out the procedure described above for the second screen as well.
→ Click the Close button to close the program.