00197975-06_UM_TX-Serie_EN.pdf - 第291页
User manual SIPLACE TX-Series 6 Station extensions From software version 713.0 Edition 01/2020 6.1 Nozzle changer 291 6.1.3.9 Changing the magazine Press t he lever (item 1 in fig. 6.1 - 10 , page 292 ), to release the…
6 Station extensions User manual SIPLACE TX-Series
6.1 Nozzle changer From software version 713.0 Edition 01/2020
290
6
6.1.3.7 Assembly
The nozzle changers are fixed to the COT insert.
Align the nozzle changer so that the sloping side points towards the COT insert.
6
6.1.3.8 Notes on operation
When you fill a magazine with a certain nozzle type for the first time, attach an adhesive label
to identify the type.
6
Open the locking plate and place the nozzles in the nozzle holders.
Close the locking plate so that the nozzles cannot drop out of the magazines.
6
6
Programming the nozzle changer is described in the SIPLACE Pro user manual.
PLEASE NOTE
The placement machine stops if magazines are missing
In the event of missing or incorrectly positioned magazines, the safety circuit will stop the
placement machine.
Use all magazine places.
WARNING
Risk of head crashes with mixed configurations!
There is a risk of head crashes with mixed configurations.
Only install the associated nozzle changer for each placement head, with the nozzle
magazines for the respective placement head.
PLEASE NOTE
Fill the magazines outside the placement machine and only replace complete mag-
azines.
CAUTION
Filling up magazines!
Before you fill magazines, make sure that all the nozzles on the Collect&Place head
have
been returned to their magazines.
PLEASE NOTE
Risk of jamming!
If components fall onto magazines, there is a risk that the locking plate could jam.
Do not allow components to drop onto the magazines.
You should therefore regularly clean the magazines and free locations.
User manual SIPLACE TX-Series 6 Station extensions
From software version 713.0 Edition 01/2020 6.1 Nozzle changer
291
6.1.3.9 Changing the magazine
Press the lever (item 1 in fig. 6.1 - 10, page 292), to release the magazine from the balls of the
snap fasteners (item 5 in fig. 6.1 - 10
, page 292). Lift the magazine off the base.
6
WARNING
Risk of head crashes with protruding lever
Any lever that is protruding over the magazine (item 1 in fig 6.1 - 10
) can result in a head
crash.
You should therefore make sure that the lever does not protrude over the maga-
zines.
6 Station extensions User manual SIPLACE TX-Series
6.1 Nozzle changer From software version 713.0 Edition 01/2020
292
6
Fig. 6.1 - 10 Changing the magazine
(1) Lever for raising the magazine
(2) Parallel pin, engages in the hole in the magazine
(3) Spring pin for triggering the microswitch for magazine recognition and the safety loop
(4) Pin of the slide mechanism, moves the locking plate
(5) Ball of snap fastener
(6) Parallel pin, engages in the slot in the magazine
(7) Locking plate in the "magazine locked" position
6
Place the magazine on the snap fastener balls (item 5 in fig. 6.1 - 10, page 292).
Press the magazine down evenly so that the snap fastener balls engage in all the snap fas-
teners at the same time.
PLEASE NOTE
Move the locking plate into the "Magazine locked" position.
Before inserting, align the magazine so that the centering pins (items 2 and 6 in fig.
6.1 - 10
, page 292) slide into the centering holes and slot.