M3plus_MaintenanceManual_e.pdf - 第39页
在线预览 M3plus_MaintenanceManual_e.pdf PDF 文档。
Chapter 3
Periodic maintenance items
Table of Contents
1. Weekly or biweekly inspection . . . . . . . . . . . . . . . . . . . . 3-1
1.1 Cleaning a nozzle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
1.2 Inspecting ball screws and linear guides of each axis . . . . . . . . . . . 3-3
2. Monthly or bimonthly inspection . . . . . . . . . . . . . . . . . . 3-4
2.1 Cleaning and lubricating a nozzle holder . . . . . . . . . . . . . . . . . . . . 3-4
2.2 Cleaning and greasing the X and Y axis ball screws. . . . . . . . . . . . . 3-5
2.3 Cleaning and greasing the X, Y and W-axis linear guide rails . . . . . 3-6
2.4 Air/mist filters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7
2.5 Cleaning the camera lens . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-9
2.6 Cleaning the signal contact point. . . . . . . . . . . . . . . . . . . . . . . . . 3-10
3. 6-month inspection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11
3.1 Cleaning and replacing the ejector filter. . . . . . . . . . . . . . . . . . . . 3-11
3.2 Cleaning the spline shaft . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-12
3-1
Periodic maintenance items
3
1. Weekly or biweekly inspection
Inspect and clean the nozzles weekly or biweekly as explained below.
1.1 Cleaning a nozzle
If solder adheres to a nozzle tip, the nozzle may be mistaken for a component or other problems may occur. If
nozzle spring-action is poor or the nozzle tip is nicked, pickup errors tend to occur frequently. To prevent these
troubles, check the nozzle condition and keep the nozzles clean.
1
Remove the nozzle from the head.
e
Always first press the emergency stop button and
then remove the nozzle from the head.
c
CAUTION
When the machine is equipped with a nozzle station, make
sure that the nozzles are returned to the nozzle station.
2
Blow air onto the nozzle tip.
Use an air blow gun to blow air onto the nozzle
tip.
43300-5E-20
3
Clean the nozzle hole.
Pass the nozzle cleaning wire through the nozzle
hole and clean the nozzle hole. While holding both
ends of the wire with fingers as shown or using a
custom handle, gently move the nozzle back and
forth.
43301-5E-20
4
Blow air onto the nozzle tip again.
After removing the cleaning wire, blow air onto the
nozzle tip with the air blow gun.
43302-5E-20
Cleaning a nozzle
Step 3
Custom
handle
Nozzle
Nozzle cleaning wire
Air blow
Step 4
Nozzle
Air blow gun
Air blow
Step 2
NozzleAir blow gun