00198271-02_UM_ShuttleExtensionTX_EN.pdf - 第41页
Assembly and User Manual 3 Assembly Instruction Shuttle Extension Edition 06/2017 3.3 Installation 39 3.3.2 Mechanical Inst allation Procedure Intermediate ledges on SIPLACE TX output conveyor side 3 Fit the two interm…
3 Assembly Instruction Assembly and User Manual
3.3 Installation Shuttle Extension Edition 06/2017
38
3.3 Installation
3.3.1 Overview
Fig. 3.3 - 1 Mounting interfaces between SIPLACE TX & Shuttle Extension
Fig. 3.3 - 2 Mounting holes position on SIPLACE TX machine frame (Input Side)
9
5
0
m
m
±
2
5
Siplace TX Input
Siplace TX Output
Interface
Bracket
Interface
Bracket
without sensor: 7.5mm – 10.5mm
with sensor: 10.5mm – 11mm
without sensor: 7.5mm – 10.5mm
with sensor: 10.5mm – 11mm
Assembly and User Manual 3 Assembly Instruction
Shuttle Extension Edition 06/2017 3.3 Installation
39
3.3.2 Mechanical Installation Procedure
Intermediate ledges on SIPLACE TX output conveyor side 3
Fit the two intermediate ledges to the machine feet of the SIPLACE TX output conveyor side.
Fig. 3.3 - 3 Intermediate ledge - right side
Fig. 3.3 - 4 Intermediate ledges -left side
(1) Intermediate ledge input conveyor - right side
(2) Intermediate ledge input conveyor - left side
(1)
(2)
3 Assembly Instruction Assembly and User Manual
3.3 Installation Shuttle Extension Edition 06/2017
40
General 3
Remove the four side covers from the Shuttle Extension. This gives you access to the fixtures
for the interface brackets and the electrical connection.
Move the Shuttle Extension to the SIPLACE TX.
Set the height of the Shuttle Extension, so that the PCB conveyor for the Shuttle Extension
is the same height as the PCB conveyor for the SIPLACE TX.
The Shuttle Extension stands on 4 feet.
Fig. 3.3 - 5 Presetting the height of the machine feet
(1) Top screw nut
(2) Bottom screw nut
(3) Shuttle Extensions feet
Turn the Shuttle Extension feet (3) with the bottom screw nut (2) so that the Shuttle Extension
has the PCB conveyor height of the SIPLACE TX.
Tighten the top screw nut (1), so that the machine feet are fixed into place.
Check the height of the Shuttle Extension and correct the height, if necessary.
(1)
(2)
(3)