00198271-02_UM_ShuttleExtensionTX_EN.pdf - 第48页

3 Assembly Instruct ion Assembly and User Manual 3.4 Electrical Connections Shuttle Extension Edition 06/2017 46 3.4 Electrical Connections 3 3.4.1 Shuttle Extension  Connect the following cables to the Sh uttle Extensi…

100%1 / 88
Assembly and User Manual 3 Assembly Instruction
Shuttle Extension Edition 06/2017 3.3 Installation
45
Finalize 3
Leave a gap of 2 mm to 8 mm between the frame of the SIPLACE TX and the frame of the
Shuttle Extension. See fig. 3.3 - 1
, page 38.
Check the transition between the Shuttle Extension and the SIPLACE TX again.
If necessary, correct the height at the feet or the fixture of the interface brackets.
Once the Shuttle Extension has been finally aligned, use the torque wrench to tighten top
screw nut (item 1 in see fig. 3.3 - 5
, page 40) to clamp all Shuttle Extension feet.
3 Assembly Instruction Assembly and User Manual
3.4 Electrical Connections Shuttle Extension Edition 06/2017
46
3.4 Electrical Connections
3
3.4.1 Shuttle Extension
Connect the following cables to the Shuttle Extension connection.
– 4 x SMEMA Cable [Item. No.: 03152800-xx]
– 1 x CAN Bus cable [Item. No.: 03133551-xx]
– 1 x Power interface cable to SIPLACE TX [Item. No. 03133550-xx]
Fig. 3.4 - 1 Electrical connection on the Shuttle Extension
(1) SMEMA connection XL1 UPSTREAM - Lane 1 to predecessor machine
(2) SMEMA connection XL2 UPSTREAM - Lane 2 to predecessor machine
(3) CAN-BUS connection
(4) SMEMA connection XL2 DOWMSTREAM - Lane 2 to successor machine
(5) SMEMA connection XL1 DOWMSTREAM - Lane 1 to successor machine
(6) POWER interface X50 to SIPLACE TX
PLEASE NOTE
Use of the circuit diagrams of the Shuttle Extension
For detail information, please refer to the circuit diagrams of the Shuttle Extension.
(6)
(1)
(2)
(3)
(4)
(5)
Assembly and User Manual 3 Assembly Instruction
Shuttle Extension Edition 06/2017 3.4 Electrical Connections
47
3.4.2 SIPLACE TX Connection
3.4.2.1 Overview
Fig. 3.4 - 2 SIPLACE TX Connection
(1) SMEMA connection T1 UPSTREAM
(2) SMEMA connection T1 DOWNSTREAM
(3) SMEMA connection T2 UPSTREAM
(4) SMEMA connection T2 DOWNSTREAM
(5) CAN-BUS Connection (for termination and connection see section 3.4.2.2
, page 48 and
3.4.2.3
, page 49)
(6) Power interface to the output Shuttle Extension
(7) Power interface to the input Shuttle Extension
(7)
(6)
(5)
(1)
(2)
(3)
(4)