JO-116-001_w.pdf - 第45页
2-8 JO-1 16 1 105-001 2.1 Starting the Program (4) After the registration (jig origin adjustment) of the master position is completed, the following window opens, enabling you to perform a feeder measurement. Reference R…
2-7
JO-116
1105-001
2.1 Starting the Program
(2) After a few seconds, the [Master Setting] button appears.
Fig. B8
(3) Press the [Master Setting] button and proceed to the registration
of the master position (jig origin adjustment).
Reference
Refer to "1. Registration of Master Position (Jig Origin
Adjustment)" in "Section 4" for how to adjust the jig to the
origin position.
2-8
JO-116
1105-001
2.1 Starting the Program
(4) After the registration (jig origin adjustment) of the master
position is completed, the following window opens, enabling you
to perform a feeder measurement.
Reference
Refer to "2. Feeder Measurement" in "Section 4" for how to
measure a feeder.
Fig. B9
2-9
JO-116
1105-001
2.2 Ending the Program
2.2 Ending the Program
Procedure
(1) Press the [ ] button located on the upper right side of each
window.
(2) The "Exit Conrmation" dialog box opens. Press the[Yes] or the
[Cancel] button.
When you select the [Yes] button, you can exit from the program.
Selecting the [Cancel] button resumes the origin window.
Fig. B10
Note
When the Windows shutdown function is valid (default), the
"Windows" system program also closes.
To invalidate the function, the authority higher than the power user is
required.
Tick the check box "Windows Shutdown after Exiting" located on
the lower left side of the "Exit Conrmation" dialog box. The "Tick"
mark disappears.
When the program is started again, press the [
] icon on the
desktop of the personal computer.