Operating Manual.pdf - 第46页
4022 591 960 62 Operating Manual 02.0 2 FCM Mu ltif lex 44 New Progr am Selection 12.Pu sh th e quick l o ck han dles of th e first ( section 1 ) base in terf ace (handle in position backwar d) FIGURE 74 13.Get, fr om it…
4022 591 96062 Operating Manual
02.02 FCM Multiflex 43
New Program Selection
8. Repeat step 5. until 6. to empty all sections (3, 2 and 1)
FIGURE 70
9. Clean the whole board-transport area so that all wasted components are
removed
FIGURE 71
x3
10.The sequence for placing /installing MBS is from Run in to Run out side
FIGURE 72
11.Get, from its storage case, the new complete positioning strip for section
1 and place it at the correct position on the base interface section 1
FIGURE 73
4022 591 96062 Operating Manual
02.02 FCM Multiflex 44
New Program Selection
12.Push the quick lock handles of the first (section 1 ) base interface
(handle in position backward)
FIGURE 74
13.Get, from its storage case, the new complete support strips for section 1,
check if there are no components attached to the magnets and place the
strips at the correct positioning on the base interface section 1
FIGURE 75
Make sure no components are attached to magnets and interfaces.
14.Repeat step 11. to 13. until all sections (2,3 and 4) are installed.
FIGURE 76
15.Remove the padlock, so that the new order can be started.
16.Use the buttons to move the rear transport rail until the board width
display shows the correct board width
FIGURE 77
4022 591 96062 Operating Manual
02.02 FCM Multiflex 45
New Program Selection
8.3 Setting Board Thickness
1. Switch the key to the Height-adjustment position and use the buttons to
adjust the tranport to the used board-thickness as shown on the display.
FIGURE 78
Height
Width
Off
0
1
Height
Width
Hei
g
ht ad
j
ust situation
2. Turn Width/height key into idle position and remove key. Close run- in/
-out covers and placement modules
FIGURE 79