00198268-02_GS_SIPLACE-Pro-14.1-R17-1_EN.pdf - 第48页

3 T utorial Getting S tarted SIPLACE Pro 14.1 (R17-1) 3.7 Exercise 6: Optimizing the Job 05/2017 Edition 48 3 Fig. 3 - 14 Result: "Optimization St atus" screen  Confirm with OK .  Save this optimized setup un…

Getting Started SIPLACE Pro 14.1 (R17-1) 3 Tutorial

05/2017 Edition 3.7 Exercise 6: Optimizing the Job

Fig. 3 - 13 Result: "Error Dialog" screen

How to remedy the error 3

 Open the SO20L component shape at My Component Shapes\Getting Started .

 Switch to the Feeders tab and assign the most suitable feeder as default feeder

(e.g. 24mm S).

 Switch to the Job tab and select the Optimize... button in the Optimization edit field.

–The Optimization Status dialog box will open and optimization will begin. Optimization

should now run successfully.

Note

A default feeder was not assigned when the missing component shape was created in

Exercise 2.

3 Tutorial Getting Started SIPLACE Pro 14.1 (R17-1)

3.7 Exercise 6: Optimizing the Job 05/2017 Edition

Fig. 3 - 14 Result: "Optimization Status" screen

 Confirm with OK.

 Save this optimized setup under the suggested name.

 Open the result setup and set alll feeders, components and nozzles to "Fixed". Save the setup.

 Set the result setup as initial setup in the Job Editor.

This setup is now the basis for subsequent optimizations. 3

3.7.3 Result Setups Reports and Brief Overview

Aim of exercise 3

The job is optimized and an optimized setup (result setup) is generated. The result setups can be

viewed in a brief overview or printed out as reports. 3

How to start the report 3

 Switch to the Job tab and select the Results... button in the Optimization edit field.

 The brief overview of optimization results will be opened for this job.

Getting Started SIPLACE Pro 14.1 (R17-1) 3 Tutorial

05/2017 Edition 3.7 Exercise 6: Optimizing the Job

Fig. 3 - 15 Result: "Brief Overview of Optimization Results" screen

 Mark the line and select the Show Recipe Results button. You will see the optimization results

for the individual placement heads, the station or line utilization and the nozzle configuration

for this recipe.