3OM-1208-011_w.pdf - 第269页
6-36 AIVEDT -ID 2.1.17 Nozzle Position Offset When the "Nozzle" tab is pressed in the "Device Offset" tab sheet and the "Nozzle Position" tab is selected, the following tab sheet appears. Fi…
6-35
AIVEDT-ID
2.1.16 Nozzle Level A Offset
When the "Nozzle" tab is pressed in the "Device Offset" tab sheet and the
"Noz. Level A" tab is selected, the following tab sheet appears.
Fig. 3F33 "Noz. Level A" Tab Sheet
Nozzle 1 through 12
Head #1, Head #2, Head #3, and Head #4
L (Height) [mm]
Each parameter indicates the offset of the bottom level of the normal
nozzles on each individual heads.
Measure each nozzle bottom level with a linear measure while the
nozzle U/D axis is zeroed and save the difference between the level and
the master nozzle level offset.
Note
These parameters are calculated using the formula "Nozzle Level Offset =
Master Nozzle Level - Measured Value of Normal Nozzle Level".
2.1 Device Offset Data
0606-009
6-36
AIVEDT-ID
2.1.17 Nozzle Position Offset
When the "Nozzle" tab is pressed in the "Device Offset" tab sheet and the
"Nozzle Position" tab is selected, the following tab sheet appears.
Fig. 3F34 "Nozzle Position" Tab Sheet
2.1 Device Offset Data
0606-009
6-37
AIVEDT-ID
Nozzles 1 through 12
Head #1, Head #2, Head #3, and Head #4
X (Horizontal), Y (Vertical) [mm]
The set parameters are used to adjust the deviations from the design
value between the head rotational center and each nozzle end position.
Xm (+)
Ym (+)
Xm-Ym : Machine Reference
Coordinate System
DD (+)
DD (+)
1
3
4
5
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
Actual Nozzle Position
Pm. Machine Reference
Coordinate Origin
2
Design Value of Nozzle Position
Fig. 3F35
2.1 Device Offset Data
0606-009