4OM-996-007.pdf - 第151页

1-84-1 AIM01ETRP 1.4.12 Replacement of Oil Filter The oil filter must be replaced after initial 500 hours and every 12,000 hours for subsequent use. • Required Items T ools : Monkey Wrench, Hex-Head Wrenches (M14 and M10…

1.4.11 Cleaning of Linear Motor's Yoke Sides

Clean the yoke sides of the linear motor every month.

• Work Procedure

(1) Turn off the power switch of the machine and the air source.

(2) Open all the feeder work area safety doors.

(3) Clean the top and bottom sides of the upper yoke and the top side of

the lower yoke with a rag.

Fig. 4A92

(4) Push the feeder carriage by hand to move it sideways.

(5) Clean the top and bottom sides of the upper yoke and the top side of

the lower yoke with a vacuum cleaner or a rag.

1.4 Maintenance Method

• Do not bring any metal of high magnetizability close

to this. Otherwise, such metal will easily be magne-

tized and attracted, causing an injury to the operator

and/or a mechanical breakdown.

• Do not bring any magnetizable material close to this.

Those who ware implanted pacemakers should not

work inside the machine. Otherwise, the pacemaker

may be affected by magnetism, leading to a serious

accident.

CAUTION

WARNING

0509-005 1-84 AIM01ETRP

Feeder Carriage

Bottom Side of Upper Yoke

Top Side of Lower Yoke

Top side of Upper Yoke

1-84-1 AIM01ETRP

1.4.12 Replacement of Oil Filter

The oil filter must be replaced after initial 500 hours and every 12,000

hours for subsequent use.

• Required Items

Tools : Monkey Wrench, Hex-Head Wrenches (M14 and M10),

Stepladder

Material: Oil Filter (Type: LND-04), Oil (SYNTHESO HT220 Approx.

14 liters), Seal Tape

Others : Plastic Bag, Rag, Gummed Cloth Tape, Rubber Gloves,

Waste Oil Container

• Replacement Procedure

(1) Detach the upper cover of the machine and open the front door.

(2) Detach the fan in front of the oil filter.

Fig. 4A92-1

(3) Enclose the oil filter area with a plastic bag to prevent oil spills and

fasten the bag with a gummed cloth tape.

Keep the front part of the plastic bag open.

Fig. 4A92-2

1.4 Maintenance Method

0509-001

Fan Anchor Bolt

Note

1-84-2 AIM01ETRP

1.4 Maintenance Method

0509-001

(4) Loosen the nut located under the oil filter with a wrench.

Pull it out by turning by hand and keep the filter cover pushed up until

the nut gets loose enough.

Note that oil will come out from the upper area of the cover

unless the cover is kept pushed.

Oil will also flow out from the lower area when the nut comes

off. Get a rag ready for use during the work.

(5) Pull out the filter cover downward.

Fig. 4A92-3

When you pull out the filter cover, note that a packing might be

attached to the cover edge.

(6) Turn the nut fastening the oil filter until it comes off and pull out the oil

filter downward.

Fig. 4A92-4

Note that the washer on the lower area of the oil filter must be

reused. Be sure not to lose it.

Note