4OM-996-007.pdf - 第79页
(7) X/Y T able Section X/Y Chute Up/Down Linear Guides Rails 3M5 Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 1) Wipe off the old grease with a rag and apply new one by hand or using a brush. There are four spots…
(6) Cutter Section Component Drop Prevention Cover
1.3 Maintenance Spots
Component Drop Prevention Cover 1D9
Daily Cleaning
When components are scattered over the
cover, follow the steps below to remove them.
1. Set the timing angle of the rotary turret to
approx. 200 degrees and turn off the power
supply before cleaning work.
2. Remove three hexagon socket head bolts
(M4) and one knurled screw and pull the
cover toward the rear side of the machine to
detach.
3. Clean the cover with a vacuum cleaner, etc.
4. Attach the cover to the machine such that
the rail section of the cover is correctly
inserted into the guide section of the machine.
5. Attach the knurled screw first and then the
three hexagon socket head bolts (M4).
Pull out.
Guide Section
Guide Section
Rail Section
Hexagon Socket Head Bolt (M4)
Knurled Screw
Fig. 4A15 Rear View of Machine
0409-002 1-15
AIM01ETRP
(7) X/Y Table Section
X/Y Chute Up/Down Linear Guides Rails 3M5
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Wipe off the old grease with a rag and apply new
one by hand or using a brush.
There are four spots.
Grease should be applied every 3 months after
the initial month.
Surroundings of X/Y Base 1W4
Every Week Cleaning
Clean the surroundings of the X/Y table
with a vacuum cleaner.
Upper Surface of X/Y Ball Screw Cover 1W5
Weekly Cleaning
Clean the upper surface with a vacuum cleaner.
* Never blow air to the upper surface.
X/Y Ball Screw X Axis 3M3
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Wipe off the old grease with a rag and
apply new one by hand or using a brush.
Grease should be applied every 3 months
after the initial month.
X/Y Ball Screw Y Axis 3M4
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Wipe off the old grease with a rag and
inject new one into the grease nipple with
a grease gun.
* Use the U- and P-type attachments.
Grease should be applied every 3 months
after the initial month.
U Type P Type
Upper Surface of X/Y Table 1W3
Weekly Cleaning
Clean the upper surface with a vacuum
cleaner.
* Never blow air to the upper surface.
1.3 Maintenance Spots
Fig. 4A16
0309-002 1-16
AIM01ETRP
Fig. 4A17
1.3 Maintenance Spots
0305-001 1-17 AIM01ETRP