4OM-996-007.pdf - 第89页

(13) Feeder Carriage Section 1.3 Maintenance Spots 0509-003 1-26 AIM01ETRP Fig. 4A28 T op View of Machine • Do not bring any metal of high magnetizability close to this. Otherwise, such metal will easily be magne- tized …

Fig. 4A27-1 Cutter Section

1.3 Maintenance Spots

0509-003 1-25 AIM01ETRP

Angular Bearing 3M7-1

Every 3 Months Lubrication

(DAPHNE EPONEX GREASE No. 1)

Inject grease from the oil inlet with a

dispense gun. (4 places)

* Use No. 20 (pink) nozzle.

Waste Tape Chute 1W10

Every Week Cleaning

Detach the cover of the cutter section and

check for remaining chips. When some

chips are remaining, remove them with a

vacuum cleaner.

Rear Surface of Cutter Cover 1M12

Every Month Lubrication

(MOLYNOC GREASE AP1)

Apply grease thinly to the shadowed area by hand or

using a brush.

* Fill the area (groove where grease pools) with grease.

(13) Feeder Carriage Section

1.3 Maintenance Spots

0509-003 1-26 AIM01ETRP

Fig. 4A28 Top View of Machine

• Do not bring any metal of high magnetizability close

to this. Otherwise, such metal will easily be magne-

tized and attracted, causing an injury to the opera-

tor and/or a mechanical breakdown.

• Do not bring any magnetizable material close to this.

Those who wear implanted pacemakers should not

work inside the machine. Otherwise, the pacemaker

may be affected by magnetism, leading to a serious

accident.

CAUTION

WARNING

Linear Guide Rails 1M13

Every Month Cleaning

Clean the carriage with an oiled rag.

Yoke Sides of Linear Motors 1M13-1

Every Month Inspection/Cleaning

Check for components and/or foreign substances

adhered to the yoke sides of the linear motors. If neces-

sary, clean the yoke sides with a rag.

Refer to "1.4.11 Cleaning of Linear Motor's Yoke Sides"

for details.

0509-002 1-27 AIM01ETRP

1.3 Maintenance Spots

Linear Scale

Linear Scale/Encoder Head 3M7-2

Every 3 Months Cleaning

Clean the linear scales and encoder heads every three months or every time the linear guides are

lubricated.

Refer to "1.4.10 Cleaning of Linear Scale Sections" for details.

Encoder Head

Fig. 4A28-1 Front View of Machine