00196376-0102_UM S-Feeder_EN.pdf - 第38页
Tape Feeder Modules Details for 3x8 mm S Feeders Inser ting the Tape 38 User Manual SIPLACE S-Feeder ► (5) Push the tape under the pickup wind ow, until the beginning of the tape is against the transport wheel, when the …
Tape Feeder Modules
Inserting the Tape Details for 3x8 mm S Feeders
User Manual SIPLACE S-Feeder 37
2.2.2 Inserting the Tape
►(1)
Only for tapes with foil overhang at the beginning of the tape
:
Wrap the foil overhang (for threading in) around the beginning of the tape material, tension the foil
along the underside of the tape and hold in place.
►(2) Thread the tape from behind into the feeder track.
►(3) Insert the tape into the feeder until you can grip the tape at the top of the feeder.
Only for tapes with no overhang at the beginning of the tape
:
Free up approx. 2-3 cm of the foil.
►(4) Pull back the foil on the top of the tape.
NOTICE
Before you insert the tape, remove any loose components from the feeder. Pay particular
attention to the area under the pickup window and the transport wheel.
Tape Feeder Modules
Details for 3x8 mm S Feeders Inserting the Tape
38 User Manual SIPLACE S-Feeder
►(5) Push the tape under the pickup window, until the beginning of the tape is against the transport
wheel, when the pickup window is closed.
►(6) Apply slight pressure to hold the tape against the transport wheel and press the green "Index" but-
ton (A). The tape will be automatically threaded in.
Briefly press the green button (A) several times, until the end of the cover tape which you pulled back
is in front of the removal edge.
►(7) Make sure that the tape perforations are firmly engaged with the transport wheel.
Tape Feeder Modules
Inserting the Tape Details for 3x8 mm S Feeders
User Manual SIPLACE S-Feeder 39
2.2.2.1 Inserting the Cover Tape in the Foil Removal
►(1) To release the pickup window, press the holddown at the front of the feeder.
►(2) Open the pickup window at the protruding hook.
►(3) Feed the cover tape upwards, through the pickup window and around the foil removal edge,
before closing the pickup window.
Make sure that the tape perforations are in the transport wheel before you close the pickup window.
Now lower the holddown to lock the pickup window into place.
►(4) Run the tape over the tape spring at the rear end of the feeder.
Make sure that the tape is run correctly between the guidance lugs of the tape spring.
CAUTION
Make sure that you remove the adhesive strip at the beginning of the cover tape on the new
tapes. The adhesive strip could otherwise damage the foil removal. The same applies to torn
splice points. Remove the adhesive strip here, before you feed the foil into the foil container.
Do not tear the foil as a stretched foil could lead to malfunctions at the foil removal point.