00196376-0102_UM S-Feeder_EN.pdf - 第78页
Dip M odule Additional Spacer (Optional) 78 User Manual SIPLACE S-Feeder 5.5 Additional Spacer (Optional) The following spacer set is ava ilable for version -03 of the DI P module : Spacer set 125 µm - 400 µm (Ite m No.:…
Dip Module
Hand Guards
User Manual SIPLACE S-Feeder 77
5.4 Hand Guards
The DIP module is set up like a feeder on the changeover table. As with a feeder, the DIP module needs
to be protected above to prevent unauthorized access. To achieve this, one of two hand guards - the
specific version depends on the machine type - must be fitted on the DIP module.
As a default, the DIP module is supplied with the high hand guard and can therefore be set up in all
SIPLACE placement machines except D1/D2.
The short hand guard supports supplied need to be used instead of the high ones when working with
D1/D2 machines.
To change the hand guards, proceed as follows:
►Loosen the two screws attached to both sides of the DIP module (1).
►Remove the hand guard.
►Fit the other hand guard on both sides of the DIP module.
NOTICE
Observe the warnings on the DIP module.
Legend:
1 High hand guard – for all SIPLACE placement machines except D1 /D2
2 Low hand guard – for D1/D2 SIPLACE placement machines
Dip Module
Additional Spacer (Optional)
78 User Manual SIPLACE S-Feeder
5.5 Additional Spacer (Optional)
The following spacer set is available for version -03 of the DIP module:
Spacer set 125 µm - 400 µm (Item No.: 00378544-xx).
The spacers sizes are available in 25 µm steps:
125 µm / 150 µm / 175 µm / 200 µm / 225 µm / 250 µm /
275 µm / 300 µm / 325 µm / 350 µm / 375 µm / 400 µm
The special spacers can be used up to a thickness of 400µ (in steps of 25µ).
The reason for this is, that when using the 275µ spacer, for example, only a measured layer thickness
of 175µ - 200µ is reached. The specified value on the spacers is therefore not the generated layer thick-
ness but only the gap between the rotary plate and the squeegee.
When using the 25µ to 75µ spacers, this effect is not quite as prominent and can therefore be ignored.
The higher the layer thickness is, the greater the difference will be between the gap and the actual layer
created.
The actual layer thickness needs to be determined by measuring the layer thickness. To do this, use the
layer thickness comb mentioned below.
5.6 Layer Thickness Comb
To check the layer thickness, we recommend using the layer thickness measuring comb shown here.
This comb can be ordered from:
Zehntner GmbH
Testing Instruments
Gewerbestrasse 4
CH - 4450 Sissach
Switzerland
Tel.: +41 (0)61 953 05 50
Fax: +41 (0)61 953 05 51
www.zehntner.com
zehntner@zehntner.com
Dip Module
Refill Recommendations
User Manual SIPLACE S-Feeder 79
5.7 Refill Recommendations
The following diagram shows a 3 ml filling level with a 25 µm spacer.
Legend:
1 Critical minimum amount
2 Minimum amount
3 Correct amount
4 Maximum amount