00197714-01_IM_REQUIRED_STEPS_BEFORE_USING_SUPPORT_MEDIA_2.0_EN.pdf - 第29页

Required Steps be fore using Suppor t Media 2.0 12/2014 Edition 29 You should also disabl e not used netw ork adapte rs to avoid con flicts. To do this: Figure 7-6 : Di sabling a ne twork ad apter ► Right-click on the ap…

Required Steps before using Support Media 2.0 12/2014 Edition

Figure 7-4: Adapter Properties

► Select the entry Internet Protocol Version 4 (TCP/IPv4) (don’t uncheck the checkbox!)

► Click on Properties.

Figure 7-5: TCP/IP Properties

► Verify your TCP/IP settings. If you don’t have a valid default gateway, don’t enter one.

► Click OK when done.

Required Steps before using Support Media 2.0 12/2014 Edition

You should also disable not used network adapters to avoid conflicts. To do this:

Figure 7-6: Disabling a network adapter

► Right-click on the appropriate (not used) network adapter and select Disable.

Required Steps before using Support Media 2.0 12/2014 Edition

8 Hints and Troubleshooting

This chapter contains some important hints and troubleshooting tips.

NOTICE

Subject to change

This chapter may describe SIPLACE product-/version-specific behaviour which

might change in future versions.

8.1 Hints for Default SIPLACE Installations

For computers installed with SIPLACE-delivered default settings:

– The account to be used for administrative Tasks including installations is

SIPLACEAdmin.

– When asked by SIPLACE Pro Setup, the account to be used for COM+Services is

SIPLACEServices.

– The non-administrative default account to be used is plr when using simple passwords

or siplace when using complex passwords.

– The default passwords for SIPLACE-created accounts are documented in the

technical information TI2008-04V08.

8.1.1 SIPLACE Pro Share Permissions

By default, SIPLACE Pro Setup creates a share in the folder where it has been installed

(default: %ProgramFiles%\SIPLACE\SIPLACE Pro). This share is required for the client

installation to be performed. Due to security restrictions (especially in domain

environments), SIPLACE Pro Setup doesn’t automatically set permissions to this share.

For default SIPLACE installations, we recommend adding the SIPLACEAdmin account to

the share permissions as described in this chapter. Also refer to the installation

documentation of SIPLACE Pro.