00197197-01_IM_SetupCenter5.0_EN.pdf - 第16页
Installation Hardware Installation Datalogic Scanner’s Cradle BC-8030 16 Installation Manual SIPLACE Setup Center 5.0 In order to con figure the cradle a scanner needs to be bound to th e cradle with the barcode "Bi…
Installation
Datalogic Scanner’s Cradle BC-8030 Hardware Installation
Installation Manual SIPLACE Setup Center 5.0 15
4.2.2.1 Connect cradle via RS232
The device may be configured to a different interface ex factory, the following steps switch to RS232 port.
► Please scan the following barcodes in the order they are printed:
► Scan the barcode “0” four times.
The scanner must have an address (temporary "0000"), so that it can get connected to the cradle. This
address will be changed / set again later by Setup Center with the automatic configuration.
Installation
Hardware Installation Datalogic Scanner’s Cradle BC-8030
16 Installation Manual SIPLACE Setup Center 5.0
In order to configure the cradle a scanner needs to be bound to the cradle with the barcode "Bind".
► Scan the barcode "Bind" now.
► If the green LED of the scanner blinks, put the scanner into the cradle.
► The green LED is now switched off and the scanner is already registered on the cradle.
The interface of the cradle can be set up now with the following barcodes.
► Scan the barcode "Restore BC-80X0 Default" to restore the standard configuration of the cradle.
► Scan the barcode "RS232 Standard" to set the interface to RS232.
The cradle is now ready for use with Setup Center.
Installation
Datalogic Scanner’s Cradle BC-8030 Hardware Installation
Installation Manual SIPLACE Setup Center 5.0 17
4.2.2.2 Connect cradle via USB
Installation of the USB-COM driver
Step 1
The installation packages for 32 bit and 64 bit operating systems are located in the “\3rdparty install-
er\Datalogic\USB-COM Driver” directory of the Setup Center installation CD.
► Choose the appropriate installation package for your operating system.
Step 2
► Click Next.
Step 3
► The Select Installation Folder dialog box prompts you to enter the name of the folder in which the
software should be installed. The system suggests a default destination folder for you.
► However, you can click the Browse button to open a dialog box in which you can enter or select the
path you want to use. If the folder you specify does not exist, it is created after having accepted a
confirmation dialog.
► Select the option Everyone.
► Click Next.