SME_DB_Feeder_User_Guide(Eng_Ver1.5) (1).pdf - 第102页
6-4 SM-Series SME DB Tape Feeder User's Manual 6.2. Example of poor splicing When the tape is cut with vinyl remaining on it It may cause clogging of t he slot for vinyl tape. When the tape splicing face is not …
6-3
Splicing
6.1.3. Tape Connection Method (Emboss Type)
For more details, refer to the manual of the splicing tool set.
Cut the end part of the tape in use
and the beginning part of the new
tape by using scissors.
Peel off the vinyl tape on the leading
end of the new tape.
Cut the H-shape tip to make it into I-
shape.
Place the I-shape tip in the tool so
that the burr is on the top.
Connect the tapes by manipulating
the handle of the tool.
Move the pressing device upward.
Push the handle of the tool and
release it, and then remove the
connected tape from the tool.
Align the vinyl connecting tape to the
hole of the connected tape and
place it on the cut area.
Peel off the other side of the
adhesive surface under the tape and
rub it so that it sticks well.
6-4
SM-Series SME DB Tape Feeder User's Manual
6.2. Example of poor splicing
When the tape is cut with vinyl remaining on it
It may cause clogging of the slot for vinyl tape.
When the tape splicing face is not straight
If the splicing face is not straight as shown in the left figure, it causes an index error.
6-5
Splicing
Splicing tip is not used for splicing the paper reel.
If the tip is not used, it causes the point to bend as shown in the picture. Therefore, it
causes an index error.
When the splicing tape provided from Hanwha Precision Machinery Co., Ltd. is not
used for splicing the paper reel
If the splicing tape provided from Hanwha Precision Machinery Co., Ltd. is not used,
the tape must be overlapped for splicing as shown above. Therefore, since the
thickness of the vinyl tape becomes greater, it causes an index error.