SME_DB_Feeder_User_Guide(Eng_Ver1.5) (1).pdf - 第69页
3-11 Maintenance 3.2.8.1. Various joints a nd areas subject to friction The following figure indicates th e areas where friction occurs due to movement when installing or operating the feeder . If noise generates or fric…
3-10
SM-Series SME DB Tape Feeder User's Manual
feeder. If any, remove them.
Figure3.12 Check foreign material on feeder reference plane
3.2.8. Removing foreign materials on the interface connector
In the case of the tape feeder, since power is supplied and communication is made through
the Probe Pin, always keep it clean of foreign materials.
Figure3.13 Removing foreign materials on the Probe Pin
3-11
Maintenance
3.2.8.1. Various joints and areas subject to friction
The following figure indicates the areas where friction occurs due to movement when
installing or operating the feeder. If noise generates or friction is felt significantly at an
indicated area, apply a small amount of grease to it.
In particular, if friction or noise occurs due to the movement of the tape guide or drain
gear, contact our C/S.
Memo The type of recommended grease for lubrication:
MICROLUBE GLY92 GREASE (MAKER : KLUBER)
Caution If the tape guide contacting the tape is stained with grease,
problems such as defective feeding accuracy and vinyl
curling may occur.
Figure3.14 SME 8mm/W4P1 feeder
3-12
SM-Series SME DB Tape Feeder User's Manual
Figure3.15 SME 12~88mm Tape Feeder