SME_DB_Feeder_User_Guide(Eng_Ver1.5) (1).pdf - 第67页
3-9 Maintenance 3.2.6. Removing foreign materi als in the vinyl collection box If there is any foreign material inside the v inyl box, defectiv e discharge of the viny l tape may occur . Unsc rew the bolts o f the vinyl …
3-8
SM-Series SME DB Tape Feeder User's Manual
3.2.4. Removing foreign materials on the feeder base
Check if there is any foreign material on the reference plane of the feeder base and if
found, remove it.
Figure3.9 Remove foreign material on feeder base reference plane
3.2.5. Noise / dust
Check whether abnormal noise occurs while using the tape feeder and whether dust and
foreign materials exist on the tape feeder
3-9
Maintenance
3.2.6. Removing foreign materials in the vinyl collection box
If there is any foreign material inside the vinyl box, defective discharge of the vinyl tape
may occur. Unscrew the bolts of the vinyl box and remove the vinyl box from the tape
feeder and then remove foreign materials.
Figure3.10 SME 8mm/W4P1: Removing foreign materials in the vinyl collection box
1: Transparent Cover
2: Vinyl Cover (Inside)
Figure3.11 SME 12~88mm: Removing foreign materials in the vinyl collection box
1: Vinyl Box
2: Vinyl Box (Inside)
3.2.7. Removing foreign materials on the location Flange
Check whether there are parts or foreign materials on the reference plane of the tape
3-10
SM-Series SME DB Tape Feeder User's Manual
feeder. If any, remove them.
Figure3.12 Check foreign material on feeder reference plane
3.2.8. Removing foreign materials on the interface connector
In the case of the tape feeder, since power is supplied and communication is made through
the Probe Pin, always keep it clean of foreign materials.
Figure3.13 Removing foreign materials on the Probe Pin