00198171-02_Technical_Training_FSE_TX-Series_EN.pdf - 第132页

8 Control and Communication Room for Your Sketches and Notes 132 Technical Training FSE SIPLACE TX-Series 01/2018 Room for Your Sketches and Notes

8 Control and Communication

8.12 Excercise: Control and Communication

Technical Training FSE SIPLACE TX-Series 01/2018 131

8.12 Excercise: Control and Communication

1. Which of the following statements is true regarding TX communication system?

A CIN Box is instead of communication board (CAN bus card).

B Vision GigE system is instead of vision hotlink system.

C There are three different bus systems, CAN bus, Gantry CAN bus and FDB.

D All of the above.

2. Which parts do not communicate with the BOXPC via the CAN bus system in TX?

A CIN-Box.

B Conveyor controller (TSP).

C FCU (Feeder control unit), MHCU and MGCU.

D I/O unit (input/ output module).

3. Which of the following statements is true regarding parts exchange?

A No setting required after exchanging a MGCU.

B No setting required after exchanging a MHCU.

C No setting required after exchanging a FCU.

D No setting required after exchanging a CIN-Box.

4. CIN-Box is connected to BoxPC with CAT5 cable, and uses CAN bus cable to commu-

nicate with subsystem.

True …………………………………………………………………………………………………

False …………………………………………………………………………………………………

5. List all of subsystems which are controlled by CAN bus.

………………………………………………………………………………………………………

6. List the parts which are controlled by FCU.

………………………………………………………………………………………………………

8 Control and Communication

Room for Your Sketches and Notes

132 Technical Training FSE SIPLACE TX-Series 01/2018

Room for Your Sketches and Notes

8 Control and Communication

Room for Your Sketches and Notes

Technical Training FSE SIPLACE TX-Series 01/2018 133